Super�SQV�Ⅳ�Universal�Application NAME�OF�PRODUCT 71008-AK001 PART�NUMBER This manual assumes that you have and know how to use the tools and equipment necessary to safely perform service operations on your vehicle. This manual assumes that you are familiar with typical automotive systems and basic service and repair procedures. Do not attempt to carry out the operations shown in this manual unless these assumptions are correct.
INSTALLATION PROCEDURE (1) Remove the cable from the negative terminal of the battery. (2) Remove the section of the intercooler piping where the SSQV is to be installed. (3) Cut a hole in the intercooler piping and weld the SSQV flange (sold separately) onto the intercooler piping.
Page 8
(6) Reinstall the removed section of the intercooler piping. (7) Connect the SSQV to the intake manifold source such as: A. Factory fuel pressure regulator B. A pressure fitting after the throttle body If necessary, use one of the provided T-fittings to splice into an existing hose. (Dia.4) (8) Install the vacuum filter between the SSQV and the source of the intake manifold pressure (with the short end going to the SSQV).
Page 9
If it is necessary to recirculate the SSQV back into the suction pipe, please refer to the instructions below. Miscellaneous hose clamps, suction pipe fitting and return hose are not included in this kit. For 1” ID Hose P/N : 71002-XA001 SSQV Recirculation Fitting (sold separately) For 19mm ID Hose P/N : 71002-AK003...
Page 10
Proper maintenance of this product is necessary in order to maintain the safety, reliability, and function of this product. - Maintenance is the responsibility of the driver/owner. - If work needs to be performed outside the scope of this manual, consult a professional. - If the vehicle gets damaged, have the repairs performed by a professional.
Need help?
Do you have a question about the Super SQV IV 71008-AK001 and is the answer not in the manual?
Questions and answers