Transportation Requirements; Instructions For Use; Cooling - Siemens PA0430M Instructions For Use Manual

Transportation requirements

The appliance is fitted with wheels to make it
easier to move around. If necessary, you can
tilt the appliance in order to move it. You
should not turn the appliance back on again
for a minimum period of one hour after
performing this procedure.
Before tilting it, empty the condensed water
from the internal tank by extracting the
water drainage pipe from its housing and

Cooling

The appliance cools and dehumidifies the air
in the room at the same time in order to create
a pleasant atmosphere.
Plug the appliance into the mains electricity
supply.
Lead the hot air expulsion tube outside. In
order to avoid excessive noise and
efficiency loss, the air expulsion tube should
be positioned as shown in Fig. 14. See
"Ways of releasing air outdoors".
Check that the plug, Fig. 1, is fitted on the
drainage pipe to prevent water from leaking
onto the support surface.
Lift the air director on the top of the
appliance. This air director is not installed
on the appliance on PA0430M models. See
figures 25 and 26 in "Heating".
Select the maximum
function, Fig. 8. (The silent cooling function
reduces the air flow on the appliance).
Requirements for use

Instructions for Use

or silent cooling
0
Fig. 8
removing the plug, Fig. 7. Do not forget to
replace the plug and reinsert the pipe in its
housing when the tank is empty.
Set the thermostat to the desired
temperature. Fig. 9. If the appliance turns
itself off automatically because the
thermostat trips, it is necessary to wait for
ambient temperature to rise 2-3°C before it
comes back on again.
20°
During air conditioning, some of the
condensed water produced evaporates
automatically and is expelled outdoors
together with the expelled air through the hot
air expulsion tube.
In conditions of extreme humidity, the
appliance accumulates condensed water in an
internal tank. When a certain level is reached
an indicator light, Fig. 3, comes on indicating
that the condensed water tank is full and
needs to be emptied. When this happens, the
appliance stops cooling the air in the room
until the water is drained, as explained in
"Transportation requirements", Fig. 7.
It is recommended that you turn the
appliance off while draining the water.
26
Fig. 7
°C
Fig. 9
30°