Related Manuals for QSC RSC-112
Summary of Contents for QSC RSC-112
- Page 1 Reference Monitor System User Guide RSC-112 3-way Screen Channel Loudspeaker RSB-212 Subwoofer RBK12 Baffl e Wing Kit (each kit contains two baffl e wings) TD-000414-00-A *TD-000414-00*...
-
Page 2: Important Safety Instructions
EXPLANATION OF TERMS AND SYMBOLS The term “WARNING!” indicates instructions regarding personal safety. If the instructions are not followed the result may be bodily injury or death. The term “CAUTION!” indicates instructions regarding possible damage to physical equipment. If these instructions are not followed, it may result in damage to the equipment that may not be covered under the warranty. -
Page 3: Package Contents
Damage to, or loss of any software or data residing on the product is not covered. When providing repair or replacement service, QSC will use reasonable efforts to reinstall the product’s original software confi... - Page 4 Q-Sys design. This User Guide tells you how to set up an RSB-212 subwoofer, with an RSC-112 loudspeaker stacked on top, and one baffl e kit for each of the two loudspeaker enclosures. For detailed information about the amplifi ers and Q-Sys hardware, refer to the respective User Guides.
- Page 5 1. Plug the NL8 connector/cable, from the amplifi ers, into the top NL8 receptacle on the RSC-112 enclosure. If you are using a fully wired NL8 cable, you may use any connector on either box.
- Page 6 The typical installation of the Reference Monitor System is to stack the loudspeakers as detailed above. However in the event that you need to suspend the loudspeakers, the RSC-112 and RSB-212 each have 16 M10 suspension points: four on top, four on the bottom and four on each side that can be used to suspend the loudspeakers.
- Page 7 Dimensions RSC-112 RSB-212 13.5 in. 15.1 in. 13.5 in. 15.1 in. 343 mm 383 mm 343 mm 383 mm — Figure 6 — — Figure 7 — 15 in. 381 mm RBK12 4.6 in. 15 in. 117 mm 381 mm...
-
Page 8: Specifications
RSC-112 RSB-212 Rated Coverage Angle (-6 dB) 90 degrees Axisymmetric Omnidirectional 55 Hz to 20 kHz 30 Hz to 20 kHz (including RSC-112) Frequency Range (-10dB) Crossover Frequencies (up to 48 dB/oct — using dedicated Q-Sys DSP) 80 to 120 Hz (selectable) 1.2 kHz... - Page 9 © 2011 QSC Audio Products, LLC. All rights reserved. QSC™ and the QSC logo are registered trademarks of QSC Audio Products, LLC in the U.S. Patent and Trademark offi ce and other countries. Tilt-Direct, Intrinsic Correction, DEEP and GuardRail are all trademarks of QSC Audio Products, LLC. All other trademarks are the property of their respective...