PROCELLA AUDIO PRELIMINARY P12 User Manual

"Thank you for purchasing a Procella Audio Active Loudspeaker!"
We recommend that Procella loudspeakers be installed and tuned by a trained Procella technician. Please consult with your
dealer or Procella Audio for assistance with determining the proper speaker setting and positions in your room.
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE THE COVER. NO USER- SERVICEABLE
PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPARATUS TO RAIN OR
MOISTURE AND OBJECTS FILLED WITH LIQUIDS, SUCH AS VASES, SHOULD NOT BE PLACED ON THIS APPARATUS
TO COMPLETELY DISCONNECT THIS APPARATUS FROM THE AC MAINS, DISCONNECT THE POWER SUPPLY
CORD PLUG FROM THE AC RECEPTACLE.
Package contents:
•
Confirm that the Voltage setting is correct for your country and that the included power cord is suitable.
•
Make sure that the ventilation openings on top of the amplifier module are free and that the position of
the P12 enclosure allows air to circulate around the amplifier module.
•
A single Procella P12 subwoofer should be positioned on the floor, against the front wall between the
Center and either the Left or Right screen speaker if no other instructions have been provided. We do not
typically recommend locating a single subwoofer on the centerline of the room. For placement of multiple
subwoofers, contact your Procella dealer or the Procella factory.
•
The Procella P12 amplifier is a High-Power, Switched-mode Class-D amplifier. Like any digital amplifier,
proper mains, grounding and signal interconnections are essential for correct operation, to avoid hum and
buzz and to achieve the best possible signal to noise ratio.
The power line should be free from disturbances caused by other electrical appliances such as
ͦ
motors, heaters and ovens, elevators, refrigerators or similar.
To minimize ground-loops, connect the Procella P12 to the same power outlet as the pre-
ͦ
amplifier or processor and run the signal cable in parallel with mains cable.
For the best possible performance, it is strongly recommended that the P12 amplifier be
ͦ
connected with a professional XLR-type, shielded 2-wire cable to a balanced output of the pre-
amplifier. Pin1=Ground, Pin2=Normal polarity ("hot") and Pin3=Inverted polarity ("cold").
Copyright © Procella Audio Sv AB
IMPORTANT SAFETY INSTRUCTIONS
- Procella P12 active subwoofer
Due to continuous R&D, specifications may change without prior notice. V1.2 Oct. 2014
PRELIMINARY
P12
User Guide
-Power cord - This User Guide