Download Print this page

DTS Ice Bank User Manual

Hide thumbs

Table of Contents

Quick Links

Download this manual

*Model may differ from the one shown here

Table of Contents

Need help?

Do you have a question about the Ice Bank and is the answer not in the manual?

Questions and answers

Summary of Contents for DTS Ice Bank

Page 1 *Model may differ from the one shown here...
Page 2 Although the information presented in this product document is believed to be accurate and reliable, no responsibility for inaccuracies can be assumed by DTS Limited. DTS Limited reserves the right at any time to change characteristics or specifications without notice.
Page 3 1 Check that the ice bank will have enough clearance around it to allow for good air flow. 2 Ensure the drain is where you want it to be. 3 Fill water to the top of the cross-bars of the plate bank. Put the lid on the ice bank.
Page 4 Water with extremely low dissolved solids (e.g. some reverse osmosis treated water) may also prevent the ice bank from running as there won’t be a conductive path across the probes of the ice bank sensor.
Page 5 3 Power on the ice bank and check that the white power light is ON. If not, check the circuit breakers in the control cabinet. 1 Rotate the cooling switch to ON. This will start the bubble pump and compressor. Allow a short time delay before the compressor starts.
Page 6 Debris that may have built up during the off season will have been flushed through, and these will affect the ice bank performance if not removed. Before you get started, have a bucket of clean water on hand. This will be used to clean the rings around the cylinder which is housed inside the water filter.
Page 7 The ice bank is supplied with the controller preset. If power supply is limited, it is possible to set up the ice bank so that the refrigeration doesn’t run at the same time as the milking plant. Set this up before milking: 1 Ensure the mains switch is ON.
Page 8 3 Check and clean the water filter. See on page 6. 4 Bleed the air from the water pump. Check that the time switch is not set to OFF. It should be set to ON or AUTO if using the timer function. For more information see www.dts.co.nz...