UPLIFT ACOUSTICS ACU001 Manual

Acoustic Panel Ceiling Hanging Kit
ACU001
Package Contents
Bracket
(qty 2)
This product is designed to be used to hang Acoustic Privacy Panels from ceilings. The provided cables can
be looped around T-bars from dropped ceilings, architectural trusses, hooks (not provided), or other features.
Make sure your ceiling can support the weight of the panels before you start installation.
© UPLIFT Desk • 800-349-3839 • info@upliftdesk.com • upliftdesk.com
Cable spool
(qty 2)
*A note before you begin:
Cinch
(qty 2)
Screw
(qty 2)
Hex Nut
(qty 2)
Step 1
Thread one end of the Cable spool through the inner hole on
the Bracket, and pull until the Cable's stopper slides into place
in the Bracket's hole, like so.
Step 2
Thread the Cable thru a large hole in the Cinch, until it comes
out from the metal nozzle on the other end.
Pull 6'' to 12'' of Cable thru the Cinch in preparation for Step 3.
Step 3
Loop the cable coming out of the Cinch around the chosen
mounting feature on your ceiling. Then feed it into the the large
hole on the other side of the Cinch until it comes out the metal
nozzle on the opposite side of the Cinch. Repeat steps 1-3 with
the second Cable spool.
Give enough slack to allow each Bracket to dangle lower to the
ground, so it's within easy reach for the next few steps.
Step 4
Locate the pre-cut holes on the long end of the Acoustic Pri-
vacy Panel. If you can't find them, measure about 6.5'' from the
right and left sides, and 3.35'' inches down from the top of the
panel.
You will only need to pop out the holes nearest the top edge.
Remove the material from these two pre-cut holes with your
finger or a pencil.
To be used in conjunction with
UPLIFT Acoustic Ceiling Cloud assemblies
...