Table of Contents
Advertisement
ENERGISER DISPLAY Models MT5, MT15, 35 & BT12, 20
Overload
1.
red LED - flashes slowly (once per pulse) when the load exceeds an acceptable level. When
this happens it is likely that the fence has a fault. Operating into an overload will NOT harm the MT15/35,
BT10 / 20. This LED also flashes quickly to indicate an energiser error.
Energiser OK
2.
ENERGISER DISPLAY MT60, 100 & BT50, 80
Overload
1.
red LED - flashes slowly (once per pulse) when the load exceeds an acceptable level. When
this occurs it is likely that the fence has a fault. Operating into an overload will NOT harm the MT60 / 100,
BT50 / 80. This LED also flashes quickly to indicate a low battery or energiser error.
Energiser OK
2.
KiloVolts
. 3
display – Shows the voltage on the output terminals of the energiser. The higher the voltage
the more effective the fence will be.
Load Factor
. 4
display – from 0 to 10, 10 being a dead short circuit, 0 being no fence load at all. Indicates
the fence load at the energiser. Useful for a quick check of fence health.
ERROR CODES
Battery powered energisers may see the red Overload LED flash twice (2) in succession, or for models
featuring digital display a reading of
themselves off to conserve the battery on re-applying the correct voltage the energiser will start up). At this
warning indication your battery needs to be re-charged to prevent permanent battery damage and loss of fence
voltage.
Should the red overload LED flash 3 or more times in succession, or for models featuring digital display
Er 03, 04 or 05
a reading
professional care.
PAGE 4 – DAKEN Users Manual
MT35 Energiser showing LED display
green LED - Flashes with each pulse to show the unit is operating correctly.
BT80 Energiser showing LED display
green LED - Flashes with each pulse to show the unit is operating correctly.
Lo b,
your energiser will require service, please return to the point of purchase for
low battery voltage.
this means
(Early models will switch
Hide quick links:
Advertisement
Table of Contents
