Gilbarco PA025800 Series Installation And Service Instructions Manual

Introduction
Purpose
This manual provides the product overview, installation instructions, troubleshooting, and
other important information for the Gilbarco
the following:
• Information previously published in the customer-specific addenda.
• Instructions for
Table of Contents
Topic
Introduction
Important Safety Information
Installation
System Operation
Testing and Troubleshooting
Important Shelf Life Information
Plug the GSM into a wall outlet immediately upon receipt. An internal battery retains
factory programming. This internal battery has a shelf life of approximately six months from
the factory start-up date. The label affixed to the GSM housing records the factory start-up
date. The battery is not rechargeable.
CAUTION
If the internal battery discharges fully, the GSM will no longer be usable. For
this reason, once you install the GSM, do not shut off the AC power to the GSM.
Reserve the internal battery power for power failure backup.
Product Overview
The GSM is a security device that encrypts (encodes) the data entered at the Card Reader In
Dispenser (CRIND
controller to the debit card network host. The site controller may be a C-2 G-SITE
Sale (POS) system, PC-based G-SITE POS system, Passport
controller.
The GSM is powered by a separate power supply, and is cabled to the site controller through
an RS-232C Port labeled "To Controller". A status Light Emitting Diode (LED) or light
displays the GSM's current state.
MDE-2597L Gilbarco® Security Module (GSM) PA0258XXXXXXX Installation and Service Instructions · January 2010
Gilbarco Security Module (GSM) PA0258XXXXXXX
®
"Installing PA025801XXXXX GSM in SMART
) device or PIN pad during a debit sale, for transmission from the site
®
Installation and Service Instructions
Security Module (GSM). This revision contains
®
CRIND™".
Page
1
6
8
18
21
POS system, or a third-party
®
MDE-2597L
January 2010
Point Of
®
Page 1