on stage WSR7500 Series Manual

WSR7500
Rack Cabinet
Congratulations on your purchase of the WSR7500 Rack
Cabinet! Please read the following instructions carefully.
We hope you enjoy your new purchase.

Components

*Parts not drawn to scale.
A. Work Surface
Also included: Allen Wrench
Tools Required: Level, Hammer, #2 Phillips Head Screw Driver, & 3/8 Wrench

Assembly Instructions

Assembly of the Metal Structure:

1.
Take the Left Vertical Leg (B) and locate the
two holes on the lower horizontal tubing. Take
the support bar (D) and install one end in the
lower two holes using two 40mm Allen Head
Bolts (Z3) and two Locking Nuts (Z2).
2.
Take the Right Vertical Leg (C) and locate
the two holes on the lower horizontal tubing.
Install the other end of the Support Bar (D) in
the lower two holds using two 40mm Allen
Head Bolts (Z3) and two Locking Nuts (Z2).
3.
Flip the assembly from Step 2 upside down
and locate the four holes on the bottom of the
legs. Take the four rubber Feet (Z1) and fasten
them into the holes. Flip the assembly right
side up and adjust the rubber feet for height
and leveling.
CAUTION
FAILURE TO OBSERVE PROPER ASSEMBLY INSTRUCTIONS, EXCEEDING THE
WEIGHT CAPACITY OR FAILURE TO OBSERVE THE WARNINGS AS MENTIONED
IN THIS INSERT MAY CAUSE STAND TO COLLAPSE, BODILY INJURY OR
EQUIPMENT DAMAGE AND WILL VOID THE PRODUCT WARRANTY.
B. Left C. Right
Vertical Leg Vertical Leg
Visit On-Stage for the most recently-updated instructions.
D. Support Bar
Z1. Feet (x4) Z2. Locking
Nuts (x4)

Attaching the Work Surface:

3.
Take the Work Surface (A). Align the metal inserts
on the underside of the Work Surface (A) with the
holes in the metal tabs on the vertical legs.
4.
Take the 12mm Allen Head Bolts (Z4) and attach
the Work Surface (A) to the vertical legs.
(Do not over tighten)

Attaching Your Rack Mountable Audio Equipment:

5.
Utilize the 6mm Screws (Z5) to mount up to 12 rack
units of gear. Follow the manufacturers recommenda-
tions for proper spacing of rack units.
Z. 40mm Z4. 12mm
Allen Head Allen Head
Bolts (x4) Bolts (x4)
STANDS
Z5. 6mm
Phillips Head
Screw (x48)