Download Print this page
EasyPro TM Series Instructions For Operation, Safety, Warranty

EasyPro TM Series Instructions For Operation, Safety, Warranty

Submersible low head waterfall pumps

Advertisement

Quick Links

TM9500 • TM9502 • TM13500 • TM13502 • TM17500
TM Series Submersible Low Head
Thank you for purchasing the TM series waterfall pump. This instruction manual
explains the product operations and gives important precautions regarding its safe
use. In order to use the product to maximum benefit, be sure to read the instructions
thoroughly and follow them carefully.
To avoid accident, do not use the pump in any way other than as described in this
instruction manual especially when you see "WARNING". After reading this instruction
manual, keep it nearby as a reference in case questions arise during use.
If this instruction manual should become lost or damaged, ask your nearest dealer or
representative for another copy.
Safety & Electrical Connections
WARNING: Verify that the voltage and frequency of the electric pump shown
on the nameplate correspond to those available on the mains.
The installer must make sure that the electric system is grounded in accordance with
local ordinances.
The plug and connections should be protected from water/rain. Before using the
pump, always inspect it visually (especially power cable and plug).
Do not use the pump if it is damaged.
If the pump is damaged, have it inspected by a qualified service center only.
Make sure that electric connections are protected from all water and moisture.
Protect the plug and the power cable from heat, oil or sharp edges.
WARNING: The power cable must be replaced by qualified personnel only.
Grounding: The plug of the power cable has a double grounding contact, so that grounding can be performed by
simply inserting the plug.
Overload Protection: EasyPro pumps have a built in thermal protection switch. The pump stops if an overload condition
occurs. The motor restarts automatically after it has cooled down.
Prior to Operation
Check the following points upon receipt of your pump:
Is the pump exactly what you ordered? Check nameplate. Has any damage occurred during shipment? Are any bolts
or nuts loose? Have all necessary accessories been supplied? We recommend that you keep a spare pump on hand in
case of emergencies. Keep this instruction manual in a place for future reference.
Waterfall Pumps
Instructions for Operation • Safety • Warranty

Advertisement

loading

Summary of Contents for EasyPro TM Series

  • Page 1 Grounding: The plug of the power cable has a double grounding contact, so that grounding can be performed by simply inserting the plug. Overload Protection: EasyPro pumps have a built in thermal protection switch. The pump stops if an overload condition occurs. The motor restarts automatically after it has cooled down.
  • Page 2 Ground Fault Circuit Interrupter device when you position the pump’s grounding wire. Voltage of power supply must match the voltage of the pump. WARNING: Must be vented in accordance with local plumbing codes. EasyPro pumps are not designed for and CANNOT be installed in locations classified as hazardous.
  • Page 3 These are not warranty items. Please take the time to verify your problem is actually a defective pump before returning. EasyPro will pay postage to return pump to you provided it is a warranty issue. If you send a pump in for warranty and it checks out...
  • Page 4 EasyPro shall not be held liable for any loss of fish, plants or any other livestock as a result of any failure or defect of this Product.

This manual is also suitable for:

Tm9500Tm9502Tm13500Tm13502Tm17500