Blue Mountain RAIN HARVESTING Leaf Eater Commercial Series Installation And Specification Manual

Installation

WHAT'S IN THE BOX? WHAT'S IN THE BOX?
• Leaf Eater Commercial Rain Head
GUTTER, EAVE & "MID" MOUNT
1. Locate the position at which you will be installing your Leaf Eater Commercial rain head.
Whether this is directly under your eave or midway down your downpipe, it should be a
minimum of 500mm above your tank inlet and tank overflow pipe.
2. Cut and bracket your bottom downpipe to the wall, being sure to offset it 30mm from the
wall.
3. Insert your Leaf Eater Commercial rain head into the pipe and mark the side flange fastening
holes. Remove your rain head and prepare the necessary fastening points. Then reinsert your
rain head and fasten it to the wall, ensuring it's adequately supported by the wall structure.
4. Cut your upper downpipe at an angle of 30 degrees to match the angle of your rain head's
stainless steel screen. Cut the pipe 50mm above the rain head screen and install it with
a 30mm offset from the wall.

MAINTENANCE

Your rain head's Clean Shield™ screen is mostly self-cleaning. However, it is prudent to
periodically inspect it to check if cleaning is necessary.
TOOLS/MATERIALS YOU MAY REQUIRE
• Tape measure
• Marker pen
• Saw
• Bracket
• Screws
• Screwdriver or drill

PRODUCT ASSEMBLY

Distance between pipe
and screen 50mm
Distance from wall
30mm
Pipe cut angle 30°
Fastening points x4
Distance from wall
30mm