Network Integration - DekoLight 843031 Manual

Product-Notes
Manual
Article No.: 843031
8. Connect and disconnect the Wifi Box with RF controller
a. Connect the Wifi Box with RF cnotroller
You have your tablet / smartphone connected with the WiFi Box and selected your
necessary virtual controller for your lghting system.
Your light source (eg LED Stripe) is connected to the RF controller.
Connect it with the power supply to the mains.
Once the light source begins to shine, press the Power button
on your virtual controller on your tablet / smartphone and keep it pressed.
The light source flashes three times and then lights up continuously.
You can now control the Light source over your virtual controller.
b. Disconnect the Wifi Box from RF controller
Disconnect the power supply to the connected RF controller and the
Light source from the mains. Then connect this again.
Once the light source begins to shine, press the Power button on your
virtual controller on your tablet / smartphone and keep it pressed.
The light source flashes nine times and then lights up continuously.
Now you can not control your light source with your virtual controller.

8. Network integration

You have the option to integrate the Wifi Box into an existing Netwzerk.
These settings can be made completely in the app.
Go in the lower menu on „Configuration", then select „Wifi Settings".
On the following screen will be searched for networks in the area, if you found your network
select it and enter the network key or password.
Deko-Light Elektronik-Vertriebs GmbH
www.deko-light.com / deko@deko-light.com
Technical Data can be changed without advance notice. Errors excepted.
25.11.2019
1 / 7