Advertisement
Quick Links
Advertisement
Summary of Contents for ESTELLE ESPRTANMTA
- Page 1 HVLP SPRAY TAN MACHINE ESSPRTANMTA-BOX1...
-
Page 3: Safety And Warnings
SAFETY & WARNINGS • A fire or explosion hazard is possible when spraying flammable materials. To assure safe operation of your spray machine, read the following instructions carefully: Always spray in a well-ventilated area. Always keep the turbine system of the High Volume Low Pressure (HVLP) Spray Tan Machine at a maximum length of hose. - Page 4 Electrical Grounding • This machine should be grounded. In the event of an electrical short circuit, grounding reduces the risk of electrical shock by providing an escape wire for the electric current. • This machine is equipped with a cord that has a grounding wire and an appropriate grounding plug.
- Page 5 OVERVIEW 6 Handle Spray Gun 2 Fluid Control Knob 7 Speed Up Button 3 Air Cap 8 On/Off Button 4 Cup 9 Speed Down Button 5 Turbine System 10 Air Hose...
-
Page 6: Operation
ASSEMBLY Attach the threaded end of the Air Hose to the Turbine System’s air outlet. Connect the other end of the Air Hose to the Spray Gun. OPERATION Adjusting Flow Control Knob The Fluid Control Knob is found at the rear of the gun. It controls the amount of solution that is sprayed through the nozzle. - Page 7 Turbine System The Turbine System has one air hose outlet on the side of the unit and is designed to run one spray gun. The turbine will pump the required air flow to apply the “Dihydroxyacetone (DHA)” solution. This turbine will provide air flow at a rate over 35 CFM at 3.5 PSI. A full body spray tan can be achieved in less than 2 minutes, You can replace the turbine pumps filter.
- Page 8 Pre-Spray Checklist for the Machine Operator Ensure the following pre-requisites are met before you begin to spray: • Proper Ventilation: To minimise the effects of any over-spray, a good airflow and an extraction system should be used. • Over-Spray Protection: Portable or fixed overspray tent which can be washed down periodically should be used.
- Page 9 Spraying the Tanning Solution Test the spray gun by spraying a small quantity into a waste basket or sink to ensure the solution is flowing properly. Ensure the recipient is standing on a bathmat, towel, or rug. To spray on the face, ensure the recipient has closed eyes and head tilted slightly. Begin spraying the face with a light coat moving down to the neck and then to the chest.
-
Page 10: Cleaning And Care
CLEANING & CARE • Rinse the fluid cup attached to the gun and wash it with clear water. • It is not necessary to empty and clean your spray gun when you pause between applications. However, ensure to clean your spray gun thoroughly at the end of your work session. - Page 11 NOTES...
- Page 12 Need more information? We hope that this user guide has given you the assistance needed for a simple set-up. For the most up-to-date guide for your product, as well as any additional assistance you may require, head online to help.kogan.com...
Need help?
Do you have a question about the ESPRTANMTA and is the answer not in the manual?
Questions and answers