Summary of Contents for FIVE OCEANS ATLANTIC Series
- Page 1 ATLANTIC ATLANTIC WINDLASS SERIES WINDLASS SERIES O W N E R M A N U A L 6 0 0 & 9 0 0 M O T O R S SAVE THESE INSTRUCTIONS SAVE THESE INSTRUCTIONS Important safety instructions are included in this manual.
-
Page 2: Table Of Contents
TABLE OF CONTENTS TABLE OF CONTENTS Introduction Specifications Protection Notice Fitting Electrical Installation Basic Requirements Accessories Gypsy Suitability Above Deck Preparation Below Deck Preparation Above Deck Fitting Under Deck Fastening Loading Rope/Chain Electrical Wiring Electric Cable Selection Wiring Control Switch Installation Wiring Diagram Operation Manual Control... -
Page 3: Introduction
1- Introduction Thank you for choosing Five Oceans. Five Oceans products are world renowned for their quality, technical innovation and proven performance. With a Five Oceans product you will be provided with many years of out- standing service. Product Support Five Oceans products are supported by a network of distributors and Au- thorized Service Representatives. -
Page 4: Protection Notice
• Five Oceans windlasses are designed and supplied for anchor control in marine applica- tions and are not to be used in conjunction with any other use. •... -
Page 5: Fitting
76mm (3”) Hole Saw 4.2 Accessories 4.2 Accessories Use only genuine Five Oceans parts and accessories to ensure top performance and eliminate the risk of voiding your warranty. For replacement parts, please visit your dealer or www.five-oceans.com 4.3 Gypsy Suitability 4.3 Gypsy Suitability... -
Page 6: Below Deck Preparation
Five Oceans recommends a minimum deck thickness of 25mm (1"), M8 Studs suit deck and packing thickness of 25-60mm (1" - 2 1/4"). -
Page 7: Under Deck Fastening
/ isolator. 4.8 Loading rope/chain 4.8 Loading rope/chain For safety and performance Five Oceans recommends the use of matched Five Oceans anchor rodes. 1. Pull out control arm. 2. Feed anchor rope/chain into entry hole. Tie off to suitable strong point in the anchor locker. -
Page 8: Wiring
5.2 Wiring 5.2 Wiring Plan the installation to suit the controls and give the operator a full view of the windlass. The wiring system should be of the fully insulated type, which avoids possible electrolytic corrosion problems. We recommend the use of type III stranded, tinned copper wire with copper crimp terminals (NOTE: we recommend that the cable are shorter if possible.). -
Page 9: Wiring Diagram
Foot Up Foot Down Circuit Motor Fuse Breaker* Solenoid top view side view Batte Battery ry 12 VDC 12 VDC *For a safe and secure installation, place the Circuit Breaker as close to the battery as possible. FIVE OCEANS ATLANTIC SERIES... -
Page 10: Operation
Turn off all power to motor windlass and release any anchor locks. When safe insert the Five Oceans wrench in to the capstan drive cap. Rotate clockwise to grip the gypsy and anticlockwise to free the gypsy controlling the rate of descent of the anchor. -
Page 11: Windlass Operating Procedures
If the rode gets too close to the underside of the windlass it will cause problems with good rode recovery and may cause damage to the line. FIVE OCEANS ATLANTIC SERIES... -
Page 12: Servicing
7- Servicing 7- Servicing WARNING! Isolate the windlass WARNING! Ensure rode is adequately using circuit breaker/isolator secured to an independent strong point 7.1 Servicing Schedule The service period is determined by the frequency of use. Professional user will need to carry out these operations more often than the weekend user. -
Page 13: Troubleshooting
This problem is a result of not securing the anchor rode combined with the gypsy drive cap being slack. Tighten the gypsy drive cap using the Five Oceans wrench and always secure the anchor rode independently of the windlass when not in use. -
Page 14: Warranty
9 - Warranty All Five Oceans® products sold by Baron USA, LLC or any of the product resellers is war- ranted to be free from defects in material and workmanship from date of purchase. 1. PRODUCT: Windlass Series (Altantic & Pacific) 2. - Page 15 Use of parts that are not original Five Oceans 6. LIMITS OF IMPLIED WARRANTY AND CONSEQUENTIAL DAMAGE: Baron USA, LLC or any of the product resellers disclaims any obligation to cover any loss of time, use of this product, freight, or any incidental or consequential claim by anyone from using this product.
-
Page 16: Product Guide
10 - Product Guide 10 - Product Guide Atlantic 600 Horizontal Windlass (Product Number: 3930) For more info click here. Atlantic 900 Horizontal Windlass (Product Number: 3442) For more info click here. Package Include (one (1) circuit breaker per windlass) •... - Page 17 FIVE OCEANS ATLANTIC SERIES...
- Page 18 HORIZONTAL WINDLASS MANUAL VOLUME ONE...
- Page 19 FIVE OCEANS ATLANTIC SERIES...
- Page 20 www.five-oceans.com VOLUME ONE © Copyright 2019 Baron USA, LLC All rights reserved...