Download Print this page
Finishing Touch FLAWLESS Quick Start Manual

Finishing Touch FLAWLESS Quick Start Manual

Facial hair remover

Advertisement

Quick Links

FACIAL HAIR REMOVER
Thank you for your purchase of FLAWLESS™, the easy and convenient facial hair remover.
Installing / Changing Battery
• Remove the FLAWLESS™ cap (Image 1).
• Grab the upper section of the unit with one hand, the bottom half with
the other, and pull apart (Image 2) to reveal the battery chamber.
• Place 1 AA battery into the compartment, making sure the positive pole
(+) is facing the bottom of the unit.
• Slide/snap the unit's bottom casing back into place (Image 2).
How to Use
• Remove the FLAWLESS™ cap (Image 1).
• Slide the switch located on the side of the unit upward into the "ON"
position (Image 3). The light will automatically turn on when the unit
is "ON".
• Gently press the head of the unit at against your skin. The unit should
not be on an angle. Proceed making small circular motions to remove
unwanted hair (Image 5).
NOTE: It is normal for the head to become warm with use.
Cleaning (Be sure unit is o )
• Twist the rotating hair removal head counter-clockwise and lift o
(Image 4).
• After each use, clean the head by using a brush (included) to wipe away
the hair residue.
• Empty any hair from the body of the FLAWLESS™ unit by turning it over
and gently tapping the sides.
• To put the hair removal head back on the unit, line up the "groove"
indicators on the cap with those on the unit and twist clockwise
(Image 4).
Tips & Pointers
• For superior results, use on hair ¼" in length or less.
• If the unit begins to slow down, clear the hair removal head and body of
any hair residue. If the unit is still running slow change the battery.
• Gentle enough to use every day.
• For airbrush-like make-up application, use daily.
NOTE: Prior to rst use, test the FLAWLESS™ on a small area. If any
sensitivity or allergic reactions occur, discontinue use immediately. Do
not use your Flawless on sensitive or irritated skin.
Replacement Head
For optimal results it is recommended that you replace your Flawless head
every 6 months. The head may need to be replaced sooner if the Flawless
loses performance or if the head becomes chipped or damaged in any
way. Go to www. awlessheads.com for special replacement head o er.
Warning
• Keep out of reach of children.
• Do not use on irritated skin. Discontinue use if skin
irritation occurs.
• Exercise caution when using around eyes.
• Do not rinse trimmer head under water.
IMAGE 1
IMAGE 4
• Do not submerge unit under water.
• Store in a cool dry place when not in use.
• Do not connect battery improperly, charge, or dispose of
in re. Battery may explode or leak.
• Dispose of old batteries according to all applicable local
regulations.
IMAGE 2
IMAGE 3
IMAGE 5

Advertisement

loading

Summary of Contents for Finishing Touch FLAWLESS

  • Page 1 • After each use, clean the head by using a brush (included) to wipe away the hair residue. • Empty any hair from the body of the FLAWLESS™ unit by turning it over IMAGE 4 and gently tapping the sides.
  • Page 2 FACIAL HAIR REMOVER QUICK START GUIDE Remove cap. (Image 1) IMAGE 1 IMAGE 2 Install battery: Grab the upper section of the unit with one hand, the bottom half with the other, and pull apart. (Image 2) IMAGE 3 Turn Unit On: Just slide gold switch upward.