ThermoWorks TempTest Blue Operating Instructions

Model
TempTest Blue
SPECIFICATIONS
Range
–58 to 572°F (–49.9 to 299.9°C)
Accuracy
±0.7°F (±0.4°C) from –58 to 392°F
(–49.9 to 199.9°C)
otherwise ±1.8°F (±1.0°C)
Response
2-3 sec. (reads to within 1°F of final
temperature of an ice bath in 3 sec.)
Resolution
0.1°
Battery
2 x AAA / 2000 hours
Sensor Type
High-performance Type K thermocouple
Connection
Requires Bluetooth 4.1 or above
Probe
0.125 dia. x 4.3 L inches
(3.3 dia. x 109 L mm) with reduced tip to
0.06 dia. inches (1.5 dia. mm)
Water Resistance
IP67
Environmental Range
–4 to 122°F (–20 to 50°C)
Dimensions
4.7 H x 1.9 W x 0.7 D inches
(120 H x 47 W x 17 D mm)
Weight
3.7 oz. (105 g)
Calibration
NIST-traceable certificate included
RADIO CERTIFICATIONS
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy, and if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Industry Canada license-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this device may not cause interference, and (2)
this device must accept any interference, including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes: (1)
l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout
brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le
fonctionnement.
Under Industry Canada regulations, this radio transmitter may only operate using an antenna
of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To
reduce potential radio interference to other users, the antenna type and its gain should be so
chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary
for successful communication.
Conformément à la réglementation d'Industrie Canada, le présent émetteur radio peut
fonctionner avec une antenne d'un type et d'un gain maximal (ou inférieur) approuvé
pour l'émetteur par Industrie Canada. Dans le but de réduire les risques de brouillage
radioélectrique à l'intention des autres utilisateurs, il faut choisir le type d'antenne et son gain
de sorte que la puissance isotrope rayonnée équivalente (p.i.r.e.) ne dépasse pas l'intensité
nécessaire à l'établissement d'une communication satisfaisante.
ThermoWorks, Inc.
Ph: 801-756-7705 Fax: 801-756-8948
P-18-008-02-d www.thermoworks.com
Order Code
292-910
Utah, U.S.A.
Ref: 547-7360 / 16.01.20
TempTest
Thermometer
Operating Instructions
Blue
™