Unika PR-1V Operation Manual

P R O F E S S I O N A L
UNiK A
5
110V 60Hz 15A
Congratulations on your purchase of PR-1V AC Line Voltage Regulator. The regulator is designed specifically for any
audio, video or computer rackmount system requiring clean, filtered, and regulated AC power for optimum operation.
Advanced Power Filtering.

PR-1V provides nine regulated, conditioned AC outlets-

eight on the rear panel and one on the front.
PR-1V input capacity is 15A; output capacity is 12A to 15A.

Usable range is an additional 10% above and below the ranges

shown in the table below.
Extreme overvoltage or undervoltage causes instant shutdown,

protecting equipment.
Extreme voltage shutdown indicator LED.

SAFETY INFORMATION
To obtain best results from your PR-1V, please be sure to read this manual carefully.
To reduce the risk of electrical shock, do not expose this equipment to rain or moisture. Dangerous high voltages are present inside the
enclosure. Do not remove the covers. There are no user serviceable parts inside. Refer servicing to qualified personnel only.
IMPORTANT SAFETY INSTRUCTIONS
PLEASE READ PRIOR TO INSTALLATION
1. Please read and observe all of the safety and operating instructions before the PR-1V is operated. Retain this instruction for future
reference.
2. The PR-1V should not be used near water – for example, near a bathtub, kitchen sink, in a wet basement, near a swimming pool, etc.
3. Do not place the PR-1V near heat sources such as radiators, heat registers, stoves, or other appliances that produce heat.
4. Route the power cord and other cables so that they are not likely to be walked on, tripped over or stressed. Pay particular attention to
condition of cords and cables at plugs, and the point where they exit from the PR-1V. To prevent risk of fire or injury, damaged cords and
cables should be replaced immediately.
5. Clean the PR-1V with a damp cloth only. Do not use solvents or abrasive cleaners. Never pour any liquid on or into the unit.
6. When left unused for a long period of time, the power cord of the PR-1V should be unplugged from the outlet.
7. The PR-1V should be serviced by qualified service personnel when:
a. The power supply cord or the plug has been frayed, kinked or cut.
b. Objects have fallen or liquid has spilled into the unit.
c. The PR-1V has been exposed to rain or other moisture
d. The PR-1V does not appear to operate normally or exhibits a marked change in performance.
e. The PR-1V has been dropped, or the enclosure damaged.
8. The PR-1V requires that a safety ground be present for proper operation. Any attempt to operate the PR-1V without a safety ground is
considered improper operation and could invalidate the warranty.
9. There are no user serviceable parts in the PR-1V. Refer servicing to qualified service personnel only.
PR-1V
A U D I O
O P E R AT I O N M A N U A L
PROFESSIONAL POWER REGULATOR MODULE
INPUT VOLTAGE
142V <75V
FEATURES
! WARNINGS
AC LINE REGULATOR
OUTPUT VOLTAGE
Output in regulation indicator.

LCD input/output voltage display.

Fast-acting user-accessible circuit breaker protects against

overload or shorts.
Very low stray magnetic field leakage.

On / off switch.

Compact, lightweight unit weights only 15.4 lbs (7 kgs).

PAGE1
I
PR-1V
AC LINE REGULATOR
O