OWL OAKWORKS Vitrectomy Recovery Seated Support Instruction Manual page 7

H ow t o U s e t h e M a j i k Vi ew
MajikView™
Mirror Close-up:
BackSide
of MajikView
• Place the mirror so that the back of the MajikView
towards you. The proper position of the mirror should then be
with the short leg resting on the Arm Rest/Desk and the reflecting
mirror in the upright position and pointing away from you. (Fig. 23)
• While looking down from above the MajikView
into the viewing mirror to see objects directly in front of you. (Fig. 24)
• Adjust the MajikView
provides comfortable viewing without strain. (Fig. 25)
• Use a book or pillow to position the mirror to accommodate viewing
objects that are higher than the Arm Rest/Desk. (Fig. 26)
F o l d i n g Yo u r S e a t e d S u p p o r t :
• Release the Arm Rest cam lock and the strap to fold down the
Arm Rest/Desk. Lock the cam.
• Release the face rest cam locks and loosen the knobs; fold
down the face rest and relock the cams and tighten the knobs.
• Make sure the push button on the seat tube is in the third hole
from the bottom. Lean the chair forward and pushing the seat.
• Use the spacer bar on the face rest as a handle for moving
the chair. Stand behind the seat and grab the spacer bar. Pull
it towards you. The chair will fold. Push the seat to lock it in
the folded position. The wheels will roll on any surface. (Fig. 27)
™ M i r ro r :
™
Viewing Mirror
™ by positioning it on the desk where it
Reflecting Mirror
Front Side of
MajikView ™
Short Leg
is facing
™
™ , look directly
Towards
Patient
Fig. 23
Fig. 24
Fig. 25
Fig. 26
Fig. 27
pg 7