Summary of Contents for Rocol EASYLINE EDGE Line Marking System
Page 1
(includes: Masking Plates; Silicone Brushes; Pointer and Central protection plate) 40141 STENCIL PACK 150mm - UPPERCASE 40144 STENCIL PACK 300mm - UPPERCASE Please refer to the respective technical data sheets for more information www.rocol.com/datasheets Product Overview The unique patented EASYLINE EDGE Line Marking System - easy to achieve ®...
Page 2
* Determined by measurement of wear resistance in accordance with ASTM D4060 using a Taber Abraser and a comparison of • ROCOL’s EASYLINE® EDGE Applicator is quick to effects of weathering by UV/condensation cycles in accordance assemble and simple to use - no specialist equipment or with ISO 11507 knowledge required.
Page 3
Technical Data Technical Data EASYLINE EDGE Applicator ® Dimensions boxed: Height: 30.5 cm Width: 25.5 cm 7.5kg Length 71.0 cm Gross Weight: 7.5 Kg Recycling Carry case shell 100% Virgin HDPE - Widely Recyclable Metallic Handle inserts Aluminium - Widely Recyclable Applicator Large plastic parts PA66 GF15 - Recyclable Batteries Required...
Page 4
Technical Data Technical Data EASYLINE EDGE Aerosol Paint ® Maximum Coverage per can: 50mm 100 metres 75mm 75 metres 100mm 55 metres No Pick-Up Time: 30 minutes ASTM D711 (Representative of light traffic) Taber Wear Index: ASTM D4060 200μm Wet Film Thickness Load: 1000g/1000cycles/CS10 Abrading wheel at 20 Cure Time 24 hours...
Page 5
Technical Data Surface Preparation All surfaces should be clean, dry and dust free before Asphalt application. Any surfaces covered in heavy grime/grease Asphalt should be free from dust, dirt, and grease etc. If should be cleaned with a suitable water washable, necessary, the surface should be cleaned by pressure washing multipurpose degreaser.
Page 6
Technical Data Assembly Instructions Click here for assembly instruction video Watch video Preparation of the Aerosol 11. Mix the aerosol contents: Hold the aerosol can upside down and shake it until the mixing balls rattle. Then shake for a further minute. Caution! Before attaching the yellow spray nozzle, ensure that all orifices are free of paint build up.
Page 7
You are now ready to start line marking! Whilst working, remove the can from the applicator every 30mins and re-shake the contents. Application Cleaning and Maintenance of the Applicator ROCOL EASYLINE EDGE aerosol paint is supplied with two Remove the making plates and centre protection plate. ®...
Page 8
T +44 (0) 113 232 2600 F +44 (0) 113 232 2740 E customer.service@rocol.com www.rocol.com ROCOL House, Swillington, Leeds LS26 8BS This document contains information based on data that is believed to be correct. However, the product may not be applicable to all uses and operating...
Need help?
Do you have a question about the EASYLINE EDGE Line Marking System and is the answer not in the manual?
Questions and answers