Advertisement
2. TECHNICAL SPECIFICATIONS
Output (Propane):
Output (EN1596):
Output (Propane):
Output (EN1596):
Air Flow:
Fuel Consumption:
Electrical Input:
LengthxWidthxHeight:
Fuel:
Heated Volume:
Output (Propane):
Output (EN1596):
Output (Propane):
Output (EN1596):
Air Flow:
Fuel Consumption:
Electrical Input:
LengthxWidthxHeight:
Fuel:
Heated Volume:
3.
INSTALLATION
Note:
3.1.
Setting heater supply voltage (LP100, LP145, LP200 & LP300 only)
Note:
3.2.
Connections
WARNING! DO NOT USE A NAKED FLAME! To check for leaks, we recommend the use of a foamy soap solution.
p
fig. 1
4.
IGNITION
IMPORTANT: To ensure continuous ventilation to the heater area, a ventilation opening must connect to the outside of the premises where the heater
is to operate.The opening must be 25cm
4.1
Switch Heater On
4.2.
Switch Heater Off
fig. 4
WARNING! If the flame shuts down during operation, before repeating the ignition operations make sure the fan is not jammed, and the air inlet
p
p
and outlet are completely free of obstructions. If the flame shuts off during normal operation due to overheating the cause of the problem must be
determined and corrected before repeating the ignition procedure.
LP35
LP145
NOT
fig. 2
for every kW, and must be set at an equal distance from upper and lower parts of heater operating area.
2
fig. 5
LP60
LP200
See safety instructions.
fig. 6
LP80
LP300
fig. 3
fig. 7
LP100
Advertisement
