(licensed program). Except as noted below, such license may not be assigned, sublicensed, or otherwise transferred by the user without prior written consent of Chainway. No right to copy a licensed program in whole or in part is granted, except as permitted under copyright law.
Chapter 1 Product intro 1.1 Intro This is the latest convenient, stylish and efficient handheld data collector, featuring the excellent performance of the Cortex-M3 core processor. The body is light and thin, easy to operate, and the high- performance ultra-high frequency function helps the retail inventory of shoes and clothing.
1.2 Precaution before using battery Do not leave battery unused for long time, no matter it is in device or inventory. If battery has been used for 6 months already, it should be check for charging function or it should be disposed correctly.
1.4 Notes Note: Using the incorrect type battery has danger of explosion. Please dispose the used battery according to instructions. Note: Due to the used enclosure material, the product shall only be connected to a USB Interface of version 2.0 or higher. The connection to so called power USB is prohibited.
Chapter 2 Installation Instructions 2.1 Appearance R2 back and front appearances are showing as follows:...
Page 9
Buttons and Indicating Lamps instruction Buttons and Lamps Description Display power status Indicating Power Lamp Display Bluetooth connection status Bluetooth Move up cursor Move down cursor DOWN Main Press to confirm current selection. button Escape current page ···...
2.3 Battery charge By using Micro USB contact, the original adaptor should be used for charging the device. Make sure not to use other adaptors to charge the device.
2.4 Buttons and function area display R2 UHF swing reader has 4 function buttons and 1 SCAN button, UHF scanning area, 1 display screen. Power key on the right side. Display 2D module Power Function Buttons SCAN Button Battery Slot...
Chapter 3 Demo Test 3.1 Install demo-uhf-bt (1.1.5) 1. Copy demo-uhf-bt (1.1.5) into internal storage of smart phone or C7x device. 2. Click to install. 3. Click icon to open demo.
3.2 Pairing Device 1. Switch on Bluetooth function of smartphone or C7x device. 2. Power on R2. 3. Click BLUETOOTH in the demo. 4. Click SEARCH to search for Nordic_UART_CW. 5. Click Nordic_UART_CW to connect.
Page 14
6. After connecting successfully, user could click 3 dots on top right to check UHF version, battery percentage and UHF module temperature.
3.3 Scan Function 1. Click START in demo or press SCAN button on R2, the UHF tags could be read. 2. Click STOP in demo to stop reading of UHF tags. 3. Click CLEAR to clean all EPC information.
3.5 UHF Tag Reading and Writing 1. The storage of one tag has 4 zones: RESERVED, EPC, TID and USER. Normally, the default password is 00000000. And TID zone can only be read, other zones can be read and written.
3.8 FCC Statement § 15.19 Labeling requirements. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Page 24
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. Hereby, Shenzhen Chainway Information Technology Co.,Ltd. declares that the radio equipment type R2 is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following Internet address: http://chainway.cn/...