Summit Treestands Run-N-Gun Ground Blind Setup Instructions

Summit Treestands Run-N-Gun Ground Blind Setup Instructions

Advertisement

SETUP INSTRUCTIONS
Keep all flame and heat sources away from this blind fabric!
This blind is made with fabric which meets CPAI-84
Specifications. IT IS NOT FIRE PROOF! The fabric will burn if
left in continuous contact with any flame source. The
application of any foreign substance to the tent fabric may
render the flame resistant properties ineffective.
DO NOT place a stove, camp fire or other flame source in or
near your blind. DO NOT cook, light , light or refuel a stove or
any other heat source inside your blind.
Do not operate any fuel burning device (lantern, heater, stove,
etc) in this blind.
Combustion consumes oxygen and can produce dangerous
levels of carbon monoxide which could lead to serious injury or
death.
Always maintain adequate ventilation inside your blind at all
times!
When positioning this blind, always carefully consider the
possibility of falling rocks or tree limbs, lightning strikes, flash
floods, avalanches, strong winds and other objective hazards.
Always use the included anchors to secure the blind to the
ground.
Never occupy the blind with all window flaps closed.
Make sure all bystanders are clear when opening or closing the
blind.
Before use, always secure the inside hub by placing the Velcro
strips around the base of the hub.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Run-N-Gun Ground Blind and is the answer not in the manual?

Questions and answers

Summary of Contents for Summit Treestands Run-N-Gun Ground Blind

  • Page 1 SETUP INSTRUCTIONS Keep all flame and heat sources away from this blind fabric! This blind is made with fabric which meets CPAI-84 Specifications. IT IS NOT FIRE PROOF! The fabric will burn if left in continuous contact with any flame source. The application of any foreign substance to the tent fabric may render the flame resistant properties ineffective.
  • Page 2 INDEX GENERAL WARNINGS AND PRECAUTIONS PG 1 SECTION 1 - INDEX PG 2 SECTION 2 - BLIND SETUP PG 2-3 SECTION 3 - BLIND TAKE DOWN PG 3 SECTION 4 - QUICK CARRY PG 4 SECTION 5 - WARRANTY PG 4 BLIND SETUP WARNING NEVER allow your hands to get near the working...
  • Page 3 BLIND TAKE DOWN BLIND TAKE DOWN 1. Remove the safety strap from the bottom of the blind hub. 2. Roll the blind over onto any side. 3. Turn away from the blind and position the center hub behind you. 4. While holding the blind with both hands, strike the hub shaft with the bottom of your boot as shown in figure 9. This will cause the blind to collapse.
  • Page 4 (A) Warranty Summit Treestands, LLC (Summit) warrants to the original retail purchaser that all products manufactured by it are free from defects in material and manufacture at the time of shipment for twelve (12) months from the date of purchase. Summit will repair or replace any part found defective if the unit claimed to be defective shall be returned to Summit, postage prepaid, within the warranty period.

Table of Contents