Arbiter Systems 120A Setup Manual

MODEL 120A SETUP GUIDE
Unpacking
Carefully check the packing material for the GPS antenna, antenna cable assembly, and any optional
accessory. Handle the GPS antenna carefully, as it may be damaged if dropped.
Connecting Power
• VERIFY that the voltage level is in the correct range (+ 8 Vdc to + 32 Vdc).
• VERIFY that the polarity is as specified on the label (– terminal connected to chassis).
• Strip the insulation 6 mm (1/4 inch) and DO NOT tin.
Configuring
Configure using any terminal program and connecting to the CONFIG PORT or to the RS-232 port.
The CONFIG PORT (micro USB) = 115200, 8, N, 1
The RS-232 port default = 115200, 8, N, 1 (user configurable)
• Open the terminal program and properly configure the port.
• Connect the computer to the CONFIG PORT using a micro-USB cable.
• Press ENTER to get the log in prompt.
• Default username = admin and then press ENTER.
• Default password = password and then press ENTER.
• Type ? and press ENTER to show a list of available commands.
Checking Firmware Version
Can check firmware version from CONFIG PORT or RS-232 port.
Must use CONFIG PORT to upload firmware.
• Log in using steps in Configuring.
• Type: firmware then press ENTER.
• Compare with firmware available from www.arbiter.com.
ANTENNA
+5 Vdc
GNSS
LOCKED PWR
FAULT
UNLOCKED
Connecting Cables
2
1. Accepts 0.05 mm
2. Strip the insulation 6 mm (1/4 inch) and DO NOT tin.
Arbiter Systems, Inc. 1324 Vendels Circle, Suite 121 Paso Robles, CA 93446 USA Tel: +1.805.237.3831
Fax: +1.805.238.5717 E-mail: techsupport@arbiter.com Internet: http://www.arbiter.com
RS-232
OUT 2
GND GND RXD TXD –
+
Figure 1: Connections
2
to 3 mm (12 AWG to 30 AWG) cable.
POWER
RELAY
OUT 1 8-32 Vdc
–
– +
+
Figure 2: Connector
PD0058300A 1