Do you have a question about the CBT3348A and is the answer not in the manual?
Questions and answers
William
May 27, 2025
How to change station on transmitter
1 comments:
Mr. Anderson
May 27, 2025
To change the station on the Craig CBT3348A transmitter, use the knob button. Rotate it clockwise to increase the frequency or counterclockwise to decrease it. For faster tuning, long-press the button to adjust the frequency in larger steps.
This answer is automatically generated
Lance
May 1, 2025
I can't get the radio station that the fm transmitter says to put it on
1 comments:
Mr. Anderson
May 16, 2025
You may not receive the radio station for the Craig CBT3348A FM transmitter if the FM channel you selected is not blank or has interference. Make sure to:
1. Tune your car radio to a blank FM channel with no signal. 2. Set the FM transmitter to the same frequency. 3. Avoid nearby strong stations that may cause interference.
Also, ensure the transmitter is properly connected to the car's cigarette lighter socket and powered on.
This answer is automatically generated
Camron Capel
April 23, 2025
Not connecting to Bluetooth
1 comments:
Mr. Anderson
May 11, 2025
The Craig CBT3348A may not be connecting to Bluetooth for the following reasons:
1. The external Bluetooth device has not been paired with the unit. Solution: Pair the external Bluetooth device to the unit.
2. The external Bluetooth device is too far from the unit. Solution: Move the Bluetooth device closer to the unit.
This answer is automatically generated
Shelley Ann Kyser
January 16, 2025
How do you reset Craig transmitter? I had it hooked up to my phone but I accidentally hit the forget on my phone now the transmitter won't show up when I'm trying to pair it again?
1 comments:
Mr. Anderson
February 3, 2025
The context does not provide specific steps to reset the Craig CBT3348A Bluetooth FM transmitter for pairing.
This answer is automatically generated
Amanda Wallace
June 17, 2025
Does the car stereo have ti be connected to an antenna for the Craig to work
Summary of Contents for Craig CBT3348A
Page 1
FM TRANSMITTER FM TRANSMITTER with Bluetooth Wireless Technology ® with Bluetooth Wireless Technology ® Owner's Manual PLEASE READ BEFORE OPERATING THIS EQUIPMENT. Model: CBT3348A Size: 148.5(W) x 210(H)mm (A5)
FCC INFORMATION This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
LOCATION OF CONTROLS USB Port 1 (For charging the external USB Device) Button USB Port 2 (For charging the external USB Device and Music playback) 4. LED Display Button Button 7. Car Cigar Lighter Plug OPERATION: For listening to music from your BT Device through the unit and your car radio, follow the steps below: Step 1: Pair the unit to your car radio:...
Page 4
2. The unit will automatically power on and the voltage of the vehicle battery will appear on the LED Display on the unit as illustrated below: 3. A few seconds later, the FM radio frequency will appear on the LED Display as below: 4.
Page 5
8. If a USB Device is already inserted to USB 2 Port, press and hold the Button approximately 2 seconds then release it to turn to USB playback mode. Press and hold again to turn back to BT playback mode. 9.
Page 6
Press and hold the buttons to adjust volume level as desired. Or, using the volume controls on your car radio to adjust volume level. Press and release the buttons repeatedly to skip tracks. 5. If the BT of the unit is paired to a Cell Phone: ...
The unit has a built-in overload/overheat protector. If the output of the unit is overloaded (or short circuited). The charger will shut off. Unplug the external USB device from the USB Port. The charge will auto reset. TROUBLESHOOTING Check the following before requesting service: SYMPTOM POSSIBLE CAUSE POSSIBLE SOLUTION...
Under no circumstance shall Craig be liable for any loss or consequential damage arising out of the use of this product. This warranty gives specific legal rights. However, you may have other rights which may vary from state to state.
Need help?
Do you have a question about the CBT3348A and is the answer not in the manual?
Questions and answers
How to change station on transmitter
To change the station on the Craig CBT3348A transmitter, use the knob button. Rotate it clockwise to increase the frequency or counterclockwise to decrease it. For faster tuning, long-press the button to adjust the frequency in larger steps.
This answer is automatically generated
I can't get the radio station that the fm transmitter says to put it on
You may not receive the radio station for the Craig CBT3348A FM transmitter if the FM channel you selected is not blank or has interference. Make sure to:
1. Tune your car radio to a blank FM channel with no signal.
2. Set the FM transmitter to the same frequency.
3. Avoid nearby strong stations that may cause interference.
Also, ensure the transmitter is properly connected to the car's cigarette lighter socket and powered on.
This answer is automatically generated
Not connecting to Bluetooth
The Craig CBT3348A may not be connecting to Bluetooth for the following reasons:
1. The external Bluetooth device has not been paired with the unit.
Solution: Pair the external Bluetooth device to the unit.
2. The external Bluetooth device is too far from the unit.
Solution: Move the Bluetooth device closer to the unit.
This answer is automatically generated
How do you reset Craig transmitter? I had it hooked up to my phone but I accidentally hit the forget on my phone now the transmitter won't show up when I'm trying to pair it again?
The context does not provide specific steps to reset the Craig CBT3348A Bluetooth FM transmitter for pairing.
This answer is automatically generated
Does the car stereo have ti be connected to an antenna for the Craig to work