shopPOPdisplays 12848 Assembly Instructions

Clear Acrylic U Shape Barrier Shield
ASSEMBLY INSTRUCTIONS

PARTS LIST:

*NO TOOLS REQUIRED
*TWO PERSON ASSEMBLY RECOMMENDED
STEP 1:
Peel off the protective plastic film from both sides of Main Panel Upright & Side Panel Uprights.
STEP 2:
Stand
up one of the
Side Panel
Uprights and
push one of
the 90 Degree
Connectors
onto the front
of the Side
Panel Upright.
STEP 4:
Repeat STEPS
2 & 3 for the other Side
Panel Upright. The 90
Degree Connectors
should face the
opposite direction of
the other Side Panel
Upright.
shopPOPdisplays makes no claim that these assembly instructions cover all details, conditions or variations, or that they cover all possible contingencies in connection with the assembly or installation of
this product. It is the Purchaser's responsibility to ensure that all components of this product are properly assembled and installed in accordance with these instructions. shopPOPdisplays assumes no
obligation or liability on account of any third-party recommendations, opinions or advice as to the assembly or installation of this product.
READ ALL INSTRUCTIONS BEFORE YOU BEGIN. DO NOT JUMP AHEAD OF ANY STEP.
90 Degree
Connector
(6 pcs)
Main Panel Upright
(1 pc)
STEP 3:
Push
the two other
90 Degree
Connectors
onto Side
Panel Upright,
spacing them
out to the
desired
distance.
Make sure all
90 Degree
Connectors
are facing the
same
direction.
Side Panel Upright (2 pcs)
1 2
page of