Black & Decker BXCSH2000E Manual page 5

sories are used to replace existing parts/accessories.
♦ WARNING: There is a risk of fire if the appliance is not
cleaned according to these instructions.
♦ Misuse or failure to follow the instructions may be
dangerous and renders the manufacturer's guarantee
null and void.
DESCRIPTION
A Power regulator control
B Thermostat
C Carry handle
D Base feet
Fitting the base feet
♦ The appliance has some base feet (D) on which the
product can be supported.
♦ To assemble the base feet, place the appliance face
down.
♦ Fit the base feet on the main body of the appliance.
♦ Attach the base feet to the body of the appliance using
the screws (Supplied with the appliance)
♦ Stand the appliance up again so as to check that the
base feet work properly.
INSTRUCTIONS FOR USE
Before use:
♦ Make sure that all the product's packaging has been
removed.
♦ Some parts of the appliance have been lightly greased,
consequently, the appliance may give off a light smoke
the first time it is used. After a short time, this smoke will
disappear.
♦ To eliminate the smell given off by the appliance when
used for the first time, it is recommended to have it on at
full power for 2 hours in a well-ventilated room.
♦ Prepare the appliance according to the function you wish
to use.
Use:
♦ Unroll the cable completely before plugging it in.
♦ Connect the appliance to the mains.
♦ Start the appliance by turning on the power regulator.(A)
- I 1250W
- II 2000W
- I 1250W + Turbo
- II 2000W + Turbo
(Original instructions)
♦ Turn the thermostat control to the desired temperature
position (B)
When you have finished using the appli-
ance:
♦ Select the minimum position (MIN) using the thermostat
control. (B)
♦ Turn off the appliance by selecting 0 on the power
regulator. (A)
♦ Unplug the appliance to the mains.
Carry handle/s:
♦ This appliance has side handles which facilitate comfort-
able transport (C).
Safety thermal protector:
♦ The appliance has a safety device, which protects the
appliance from overheating.
♦ When the appliance switches itself on and off repeatedly,
for reasons other than the thermostat control, check to
ensure that there are no obstacles that impede correct
air entry or expulsion.
♦ If the appliance turns itself off and does not switch itself
on again, disconnect it from the mains supply, and wait
for approximately 15 minutes before reconnecting. If the
machine does not start again seek authorised technical
assistance.
CLEANING
♦ Disconnect the appliance from the mains and let it cool
before undertaking any cleaning task.
♦ Clean the equipment with a damp cloth with a few drops
of washing-up liquid and then dry.
♦ Do not use solvents, or products with an acid or base pH
such as bleach, or abrasive products, for cleaning the
appliance.
♦ Do not let water or any other liquid get into the air vents
to avoid damage to the inner parts of the appliance.
♦ Do not submerge the appliance in water or any other
liquid, or place it under a running tap.
♦ If the appliance is not in good condition of cleanliness, its
surface may degrade and inexorably affect the duration of
the appliance's useful life and could become unsafe to use.
♦ Remark: When the appliance is used as a heater after
long periods in storage or after having been used solely
as a fan a small amount of smoke may be produced.
This is not important and is due to the heater burning
dust deposits which have accumulated on the heating
ENGLISH
5