Advertisement
Parts list:
Assembly instructions:
1.
Align the dimples of the PUK to the
ridges of the PIT.
3.
IF NECESSARY
Due to the production process the screw holes
might be narrower than expected. You can widen
them by using your screwdriver as shown in the
picture.
5.
Put the bracket on the PIT and secure it with
the 20mm Z2 screws.
Made in Germany & Distributed by PRIMA KLIMA TRADING CZ s.r.o.
Radnice 594, 33828 Radnice u Rokycan, Czech Republic
Phone: +420 371795340, Fax: +420 371795343, Email: support@primaklima.com, www.primaklima.com
teaspoon
you need screwdriver
4x PH2 screws
1x PUK
60mm
8x Z2 screws
1x Bracket
20mm
2.
To position the PUK inside the PIT correctly it is
advisable to use an object, like a teaspoon, that
will glide around the outside of the PUK but inside
the PIT.
4.
Secure the PUK by screwing the PH2
screws through the PUK into the PIT.
6.
The PITPUK is ready. For critical applications
you can use tape to make sure that the gap
between the PIT and the PUK is airtight.
1x PIT
The first production
run of PITs turned out
a bit too narrow. We
apologise for any in-
convenience caused.
Advertisement
