Using Your Hydro Pitcher - Cook's Companion Hydro Pitcher Manual

Using Your Hydro Pitcher

 H2+: For best results, we recommend using the Condition cycle prior to using the
Hydrogen functions. The H2+ function will use electrolysis to increase the Hydrogen
in your water to approximately 700ppb (parts per billion). Touch the H2+ function on
the control panel and the display will show "13," indicating 13 minutes. The pitcher
will then begin to look slightly cloudy and the LED lights will begin changing colors. At
the very end of the cycle the water will spin itself once more to signify the end of the
cycle. Once the cycle has been completed you will hear 6 beeps and the water
generator will power down. Enjoy the Hydrogen water immediately, as the
Hydrogen will begin to slowly dissipate as it sits. In order to consume the most
hydrogen rich water, it is recommended to drink the water within 30 minutes of the
completion of the H2 or H2+ cycle. The amount of Hydrogen in the water will return
to zero in approximately 1-½ hours.
 Clean: It is recommended to use the clean function every 10 uses. To use this
function, first press the power button so all displays are lit up. Then, press the Clean
function on the control panel. Once this function is pressed, the display will show "01"
indicating 1 minute and the LED lights in the pitcher will begin to change color. Once
the cycle is complete, you will hear 6 beeps and the device will power off. Do not
drink the water after the Clean cycle. Pour the dirty water in the pitcher out and refill
with water to begin using again.
 To switch functions while one is still in process, first press the current function's
button to stop the cycle. Once the cycle has been stopped, all four functions will light
up and you can select which function you would like to use. You can also press the
Power button at any time to stop any function.