Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Clarke CUH100
Summary of Contents for Clarke CUH100
- Page 1 Under Bonnet Inspection Lamp Model CUH100 PART NO:3220823 USER GUIDE 05/08...
-
Page 2: Specifications
INTRODUCTION Thank you for purchasing this CLARKE Inspection Lamp. Please read this manual thoroughly and follow the instructions carefully. Before attempting to use the lamp, thoroughly familiarise yourself with the lamp & its operation. In doing so you will ensure the safety of yourself and that of others around you, and you can look forward to the lamp giving you long and satisfactory service. -
Page 3: General Safety Rules
When not in use, unplug from the mains pwer supply and store in a safe dry area. PARTS AND SERVICE For spare parts and service, please contact your nearest dealer, or CLARKE International, on one of the following numbers. PARTS & SERVICE TEL: 020 8988 7400 / FAX: 020 8558 3622 or e-mail as follows: PARTS: Parts@clarkeinternational.com... -
Page 4: Electrical Connections
Should you wish to replace a detachable fuse carrier, ensure that the correct replacement is used (as indicated by marking or colour code). Replacement fuse covers can be obtained from your local Clarke dealer or most electrical stockists. Fuse Rating The fuse in the plug must be replaced with one of the same rating (3 amps) and this replacement must be ASTA approved to BS1362. -
Page 5: Operation
OPERATION Fig 1. Insert the lamp into the brackets on the support bar & secure with the spring clips as in Fig 1. Attach to the underside of the car bonnet by pulling the spring-loaded bracket arms apart as in Fig 2 and allowing them to close around the bonnet sides. -
Page 6: Maintenance
MAINTENANCE Keep the lamp clean by wiping with a clean dry cloth. DO NOT use abrasive cleaners. Check the cable for wear or damage. If the plug is broken, remove the lamp from service and have it repaired by a qualified electrician. Allow the lamp to cool down for a few minutes after switching off, before performing any maintenance tasks. -
Page 7: Declaration Of Conformity
The CE mark was first applied in: 2006 Product Description: Under hood Inspection Lamp Model number(s): CUH100 Serial / batch Number: Current Manufacture. Date of Issue: 10/06/2008 Signed A.C. AIKEN Senior Manager Clarke International. CUH100 -DOC- RV1.doc Page 1 of 1...
Need help?
Do you have a question about the CUH100 and is the answer not in the manual?
Questions and answers