Unpacking And Installation; Power Supply - Ricatech PR390 User Manual

• Do not mix old and new batteries.
• Battery life is affected by the volume. The lower the volume, the longer the life of the batteries.
• Power consumption is very low when the radio is turned off. Let the batteries remain in the
compartment so that the station stays tuned.
INSTALLATION

Unpacking and installation

1. Carefully remove the unit from the box and remove the packaging material.
2. Unwind the power cord and extend it fully.
3. Unwind the FM wire antenna and extend it fully.
4. Place the unit on a flat, stable surface close to a power outlet so that it is not exposed to direct
sunlight or sources of extreme heat, dust, moisture or strong magnetic fields.
5. Plug the power cord into the mains supply.

Power supply

The system is only designed for use with 230 VAC, 50 Hz. If the product is used with another power
source it can be damaged – damage of this kind is not covered by the warranty.
NOTE!
The product is equipped with a polarised plug. If the plug does not fit into your existing power outlet,
you probably have an old unearthed power outlet. Allow an authorised electrician to change this to an
earthed socket.
1. Plug
2. Socket
USE
NOTE!
1. Turn on the radio: Move the power switch to the I position
2. Turn off the radio: Move the power switch (on the left-hand side) to the 0 position
Radio
1. Turn on the appliance by pressing the power switch and set a low volume.
2. Press the MW /FM buttons to the desired band, MW or FM.
3. Set the required station using the tuning dial.
4. Turn the volume control to the required level.
5. Turn off using the power switch when you've finished listening.