Wiring Diagram - 12-Voltair 12V6CF Owner's Manual

WIRINg
Disconnect (red dotted) wire
from the solenoid and reattach
to the wire that goes from the
pressure switch to the wire
(green dotted) that goes to the
toggle switch.
OPTIONAL
"A ir W here A nd Wh e n Yo u N e e d I t ! "
®
OPTIONAL
REMOTE SWITCH
12 VdC POWeR SOURCe
This can be any 12 power source. There are two types
of power sources.
1- Direct- This is a power source that has continuous 12
VDC whether the ignition is on or off. The disadvantage
of this is that if the switch is left on over the weekend
and an air leak were to develop- the 12-Voltair will run
to maintain air pressure and may leave you with a dead
battery when you get back.
2- Ignition Controlled- This is a power source that only
has 12 VDC power when the keyed ignition is in the on
position. The advantage of this is that the 12-Voltair will
only run when the ignition in on. Consult your vehicle
manufacture to help you locate an ignition controlled 12
VDC.
Follow this line if you are not using a circuit
breaker.
Use this dotted line if you are using a circuit
breaker.
Page 12