Maintenance - WilTec JEBAO SK-30 Operation Manual

M odel: S K - 30， S K- 4 0 ， SK- 5 0
INT RO D UCT IO N
Jebao Skimmer are carefully inspected and tested to ensure both safety and operating performance.
However, failure to follow the instructions and warnings in this manual may result in Skimmer damage
and/or serious injury. Be sure to read and save this manual for future reference.
WARNING

This Skimmer is supplied with a grounding conductor and a grounding type attachment plug. To
reduce risk of electric shock, connect only to a properly grounded outlet. (not concerning SK-50)

Do not remove the grounding pin from the plug. (not concerning SK-50)

Do not connect to any voltage other than that shown on the Skimmer. (not concerning SK-50)

Do not Skimmer flammable liquids.

The Skimmer floated water superficial, but the pump must be submersible

Do not use with water above 35℃.
The supply cord cannot be replaced. If the cord is damaged the appliance should be scrapped. (not
concerning SK-50)
CAUTION
Always disconnect from electrical outlet before handling the Skimmer. (not concerning SK-50)
Don't operate without water. (not concerning SK-50)
Do not lift the Skimmer by the power cord. (not concerning SK-50)
Operate in freshwater only.
This product must not be disposed together with the domestic waste.
This product has to be disposed at an authorized place for recycling of
electrical and electronic appliances. (not concerning SK-50)
By collecting and recycling waste, you help save natural resources, and
make sure the product is disposed in an environmental friendly and
healthy way. (not concerning SK-50)
INSTALLATION AND PERFORMANCE
Please according to the Figure 1 installation Attaches onto filter pump for
skimming
The floating of the skimmer is adjustable and when the trees around my
pond started to drop their leaves, it cleared the surface extremely well.
The inner basket pulls out easily for cleaning.
A clogged or dirty intake screen will greatly reduce performance.
If the Skimmer is used on a dirty surface, raise it slightly to reduce the
amount of debris contacting the intake.
The Skimmer is to be supplied through a residual current device (RCD)
with a rated residual operating current not exceeding 30mA.

MAINTENANCE

To clean Attaches onto filter pump for skimming, remove the back cover
and the impeller.(see figure 2)
Use a small brush or stream of water to remove any debris
© by WilTec Wildanger Technik GmbH
http://www.wiltec.info
Warter ring
Filter cartoon
Skep
Auricular angle
Main body
Warter pump
Bottom cover
Seite 10