Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Sit-Stand Flytta 2
Summary of Contents for Sit-Stand Flytta 2
- Page 1 ASSEMBLY GUIDE ® STANDING DESK MEGASTORE...
- Page 2 Inventory...
- Page 3 Step 1. Step 3. NOTE: Do not fully tighten the screws. NOTE: Push plastic inserts ( F ) until they click into place. Step 4. NOTE: Do not fully tighten the screws. Step 2. NOTE: Metal frame ( C ) should slide under the plastic inserts ( F ) .
- Page 4 Step 5. Step 7. Step 8. NOTE: Fully tighten the screws ( K ) . Attach parts B before parts E. Step 6. Step 2 NOTE: Bolts on the far edge of the legs must be able to hook into the crossbar. Step 1...
- Page 5 Step 9. Step 10. Max 1730mm Min 1150mm NOTE: Fully tighten the screws. Step 11. Max 1730mm Min 1150mm...
- Page 6 Step 12. Step 13. Step 14.
-
Page 7: Reset Procedure
Reset Procedure Lower the frame to its lowest position by pressing the down arrow on the hand control. Release the button. Press the button again and keep it pressed for 10 seconds, the reset is now carried out and the frame is ready to use. Fahren Sie die Tischplatte mit der Taste “Pfeil nach unten“... -
Page 8: Operation
Memory Setting Control Panel Operation Save Key Memory Position Keys 1, 2, 3 and 4 Up Key Down Key Saving a desktop position 1. Adjust the desktop to the position you want to save (the display will show the desktop height e.g. 73cm) 2. - Page 9 Memory Setting Control Panel Fault Protocol The display reads HOT. Cause Remedy The COMPACT control unit is fitted Wait until the control unit has cooled with overheating protection. Over down and HOT is no longer displayed. heating has caused the control unit to The COMPACT control unit is then stop.
Need help?
Do you have a question about the Flytta 2 and is the answer not in the manual?
Questions and answers