Jorvet Face Shield Instruction Manual

Figure 1 Step 1
Step 3
Back of Shield
B A
Step 5
1
Peel the protective film from both sides of the face shield and clear strap.
2
Slide the clear strap through the two slots on the shield.
3
Line up the holes in the shield and clear strap, and secure them in place by pushing a rivet through the holes on
both sides of the clear strap.
4
Insert the blue strap through slot A of the clear strap. Be sure end of the blue strap is inserted into slot A from the
front of the face shield.
5
Next, loop the blue strap through slot B. Be sure the end of the blue strap is on the inside, touching the head.
6
Repeat Steps 4 and 5 on the other end of the blue strap.
7
If necessary, adjust the length of the blue strap by pulling either end until the face shield is comfortable and secure.
Face shield assembly video:
https://www.jorvet.com/product/jorvet-face-shield-20-pk/
P. 800.525.5614
Step 2
Step 4
Step 5
F. 970.663.5042
1450 N. Van Buren Avenue, Loveland, CO 80538
Face Shield
Instruction Manual
Step 3
Front of Shield
A B
Step 4