Summary of Contents for Crosswater Digital Solo
- Page 1 Solo water This operation and care guide must be left with the user. control system Operation and care guide SOLOUSER DIGITAL WATER CONTROL AT YOUR FINGERTIPS DIGITAL WATER CONTROL AT YOUR FINGERTIPS...
-
Page 2: Table Of Contents
Important: Once powered up, the control must be programmed within one hour, this will set the maximum temperatures, maximum run time, hygiene intervals and ambient light. Operating the Solo water control system Self check mode To turn ON / OFF... -
Page 3: Operating The Solo Water Control System
DIGITAL WATER CONTROL AT YOUR FINGERTIPS Operating the Solo water control system To turn ON To turn OFF Press the control once, the Press the control once, the control will illuminate Orange water and light will turn off. and water will start to flow. -
Page 4: Setting The Memory
CONTROL AT YOUR FINGERTIPS Setting the memory Up to three memory settings To set the 2nd memory, press can be stored. twice quickly in off position, then follow the same sequence Press the control once. as memory 1. Set the desired To set memory 3, press quickly temperature. -
Page 5: Cleaning (Safe) Mode
DIGITAL WATER CONTROL AT YOUR FINGERTIPS Cleaning (safe) mode Press the control until the Green light appears, then release, this will disable the control for 45 seconds to allow the control to be cleaned without turning on the control. Thermal disinfection The pipes will flush through at Caution: The water is hot the hottest temperature your... - Page 6 CONTROL AT YOUR FINGERTIPS Activation set up Important: Once powered up, the control must be programmed within one hour, this will set the maximum temperatures, maximum run time, hygiene intervals and ambient light. Note: If the activation setup is not completed within one hour, power off the unit and leave it for 20 minutes, then start again.
- Page 7 DIGITAL WATER CONTROL AT YOUR FINGERTIPS Maximum run time Hygiene interval Ambient light Number Value Number Value Control Adjustment of blinks of blinks colour 5 seconds 1 Day Light inactive 8 seconds 2 Days Cyan Light cyan 10 seconds 3 Days Blue Light blue 15 seconds...
-
Page 8: Cleaning / Maintenance
Please do not open the processor unit as this will invalidate your warranty. Servicing / contact info In the unlikely event that you are experiencing difficulties with your new Crosswater Digital product, please contact the Crosswater Technical Advice team on: 0345 873 8840 or via e-mail –...
Need help?
Do you have a question about the Solo and is the answer not in the manual?
Questions and answers