Sanus Elements PowerBridge ELM805 Installation Instructions

6901-002001 <01>
R
(Check Local Building Code Requirements)
~ REQUIRED FOR INSTALLATION ~ (NOT SUPPLIED) ~
BUILDING ELECTRICAL WIRE 12-2 or 14-2 IN-DOOR type.
Best known as ROMEX - non-metallic (NM) type building electrical wire*, can be purchased at home supply/hardware stores.
R
Check local Building Codes for specific types of building wire requirements, such as MC, BX, or AC type wire.

~ TOOLS REQUIRED ~

Stud Finder ~ Tape measure ~ Pencil ~ Small Level ~ Drywall Saw/Sharp Utility Knife ~ Phillips head and flat blade screwdriver
Wire-stripper ~ Needle Nose Pliers ~ Electrical Outlet Tester

* IMPORTANT PRODUCT INFORMATION *

*BEFORE YOU START: Check with your local building jurisdiction as to permit, license or code requirements for installing wire or outlets
.
within a wall Some municipalities require an electrical inspection for any modification of electrical work. Sanus Systems, recommends all
electrical work to be inspected by a licensed electrical inspector.
THIS PRODUCT IS NOT TO BE INSTALLED, DIRECT WIRED, CONNECTED OR BRANCHED TO THE BUILDING ELECTRICAL CIRCUIT/WIRING
SYSTEM !
INSTALL THIS PRODUCT ONLY AS AN ELECTRICAL EXTENSION PLUG-IN DEVICE TO AN EXISTING, A/C GROUNDED OUTLET TO
ENERGIZE A/C POWER USING A UL LISTED PLUG-IN CORD SET WHEN INSTALLED WITH SPECIFIED CODE COMPLIANT BUILDING
ELECTRICAL WIRE. Install this product to meet National Electrical Code and or State/Local Building Code as to requirements for installing
electrical building wire and outlets as a single EXTENSION CIRCUIT, without modification or alteration to the building electrical circuit/wiring
system.
THIS PRODUCT MUST BE INSTALLED IN A UL CLASSIFIED SINGLE GANG ELECTRICAL JUNCTION BOX TO MEET CODE COMPLIANCY AND
TO ASSURE SAFETY. The supplied non-metallic junction boxes may not meet some local code requirements, as metal junction boxes may be
required for specific types of building wire requirements, such as MC, BX, or AC type wire.
Please read and understand all instructions. Follow WARNING and CAUTION labels on the product. Use 12-2 or 14-2 copper utility [CU] wire
only with this product. This product is rated to use with an existing A/C outlet 15-amp 125v grounded circuit only. For shock protection, do
not install this product to a non-grounded outlet/system.
Do not install this product near water, example, near a sink, tub, shower, swimming pool or laundry area.
Manufacturer is not liable for damages due to improper installation methods not followed herein or as required by national electrical or local
building code. Installation Code Compliancy is the responsibility of user and or installer and not of the Manufacturer or it's agents.
If you are not skilled with running wires through wall; it is strongly recommended that a qualified installation professional should install this
product.
This product does not have built-in electronic circuitry for surge protection or A/C filtering.
It is recommended that this product be connected to a quality surge-protector/power conditioner for equipment protection.
Sanus Systems, the Manufacturer, it's agents, suppliers, and affiliates, shall not be liable for any damages, not limited to; misuse, acts of nature, verbal
and written expression and improper installation. Improper installation is determined such to include, not limited to, non-code compliant installation,
product modifications, alterations, adjustments, and connections using non-code compliant methods and or materials. Your Sanus ELM805 has a limited
one year product warranty against manufacturer's defects. If you have any questions or experience any problems with your Sanus Elements product,
please contact Sanus Systems Customer Service.
Maximum claim liability not to exceed the product purchase price or Manufacturers Suggested Retail Price.
Sanus Systems 2221 Hwy 36 West, Saint Paul, MN 55113 USA
Customer Service: 1-800-359-5520 • 651-484-7988
info@sanus.com • www.sanus.com
©2009 Milestone AV Technologies. All rights reserved. Sanus is a division of Milestone.
All other brand names or marks are used for identification purposes and are trademarks of their respective owners.
*ROMEX ~Well known brand of non-metallic (NM) building wire, is a Registered Trademark of Southwire Corporation. Used with permission.
R