Operation Instructions - NewAir Magic Chef Top Loading Water Dispenser Manual

Magic Chef® Water Dispenser Product Guide

Operation Instructions

If you do not plan to use the water heating function for more than three days, we
recommend that you turn the HOT switch to the "OFF" position.
WARNING:
IMPROPER USE OF THE GROUNDED PLUG CAN RESULT IN THE RISK OF ELECTRICAL SHOCK. IF THE
POWER CORD IS DAMAGED, HAVE IT REPLACED BY AN AUTHORIZED AVANTI PRODUCTS SERVICE
CENTER.
Steps to replace water bottles
To replace the bottle:
1. Remove cap.
2. Use a clean cloth to wipe off the neck of the bottle.
3. Carefully lift the bottle (approx. 40 lbs.) using your legs and not your back. Do not place hands
on the neck or opening of the bottle while placing it into the reservoir.
4. Insert the water bottle into the water intake over the reservoir opening so that it settles
properly on it.
5. When a new bottle is installed, you must open the hot water faucet and remove no less than 4
full cups of water to ensure the water flows properly and the water reservoir is full.
Hot and Cold Power ON/OFF Indicator Lights
Once the power switches on the back of the unit are turned on for the HOT and COLD water systems,
the lights in the switches will illuminate to let you know that your hot and cold water are both
functioning normally.
Hot Water Indicator Light
Turn the heating switch on, on the back of the unit. The red indicator light (on the front of the unit) will
illuminate and the heating process will start. When the water reaches the correct temperature (185°-
203°F / 85° - 95°C), the red light will turn off automatically. When the temperature drops below 176°F
(80°C), the red indicator light (on the front of the unit) will illuminate again, indicating that another
heating process has started.
9