Panasonic SF2B Series Instruction Manual page 54

2) When using emission halt function
This device incorporates the emission halt function. Using this function, it is possible to simulate
the light blocked status.
<Reference>
When the test input is kept open (for the wiring synchronization using a 8-core cable, connect to 0V or +V
for the beam synchronization using a 4-core cable), the emitter stops emission. In this condition, if this de-
vice operates properly, the control output (OSSD 1 / 2) of the receiver turns OFF.
Setting procedure and
check items
Wiring synchronization
using 8-core cable
Before power is ON
Connect the emis-
sion halt input to 0V
or +V
1
Beam synchronization
using 4-core cable
Before power is ON
Open the emission
halt input
Wiring synchronization
using 8-core cable
After power is ON
Receiver 's control
output (OSSD 1 / 2)
ON
(Normal operation)
2
Beam synchronization
using 4-core cable
After power is ON
Receiver 's control
output (OSSD 1 / 2)
ON
(Normal operation)
Note: The status of the setting indicators (red) of the emitter and the digital error indicators of the receiver shown above is
when the frequency selector is set to "2". Only one of the setting indicators of the emitter lights up and only the middle
bar of the digital error indicators of the receiver lights up in red when the selector is set to "1". (This is not an error.)
54
Ramco Innovations | www.ramcoi.com | 800-328-6236 | nsales@ramcoi.com
: Lights up in red, : Lights up in green,
Indicators
Emitter
Beam-axis alignment
indicator
Operation indicator
Emission halt indicator
Fault indicator
Setting indicator
Beam-axis alignment
indicator
Operation indicator
Emission halt indicator
Fault indicator
Setting indicator
Beam-axis alignment
indicator (Green)
Operation indicator (Green)
Emission halt indicator
Fault indicator
Setting indicator
Beam-axis alignment
indicator
Operation indicator (Green)
Emission halt indicator
Fault indicator
Setting indicator (Red) (Note)
: Lights up in orange,
Receiver
Beam-axis alignment
indicator
OSSD indicator
Incident light intensity indicator
Fault indicator
Digital error indicator
Beam-axis alignment
indicator
OSSD indicator
Incident light intensity indicator
Fault indicator
Digital error indicator
Beam-axis alignment
indicator (Green)
OSSD indicator (Green)
Incident light intensity indicator
(Green)
Fault indicator
Digital error indicator
Beam-axis alignment
indicator
OSSD indicator (Green)
Incident light intensity indicator
(Green)
Fault indicator
Digital error indicator
(Red) (Note)
© Panasonic Industrial Devices SUNX Co., Ltd. 2016
: Turns OFF
Control output
OSSD 1 OSSD 2
OFF
ON