HSS Hire 68820 Operating & Safety Manual

EQUIPMENT CARE

Never push the equipment beyond its design
limits. If it will not do what you want with reasonable
ease, assume you have the wrong type of pump for the
job. Ask at your local HSS Hire Shop for advice.
Keep the equipment clean. You will find this less of a
chore if you clean up regularly rather than wait until the
end of the hire.
Handle hoses with care. Never lay them over sharp
edges, where they could be walked on, or anywhere
else that exposes them to the risk of damage.
When not in use, store the equipment somewhere
clean, dry and safe from thieves. Protect this
equipment from frost and freezing temperatures.
Never pump anything other than clean water,
never use it to pump dangerous or corrosive liquids.
Always de-pressurise the system following the
recommended method. Releasing the pressure in any
other way could cause the pump to lock up.

FINISHING OFF

To release the pressure in the system, open the shut
off valve or the 'V2' valve.
Drain down the system being tested then disconnect
the pump' s pressure hose.
Finally, coil the hose neatly in the box ready for
return to your local HSS Hire Shop.
Contact your local
0990 282828
...any comments?
If you have any suggestions to enable us to improve
the information within this guide please fax your
comments or write to the Product Manager at the
address below
Fax: 0181-687 5001
©HSS Hire Service Group Plc 1998 No. 748/01
Group Office: 25 Willow Lane, Mitcham, Surrey CR4 4TS
Web Site: http://www.hss.co.uk
Operating & Safety Guide 748
Hire Shops
Manual Pipe
Pressure Tester
For testing pressurised systems
quickly and efficiently.
Code 68820