Customer Service Hotline. Intended use Safety information Technical data Before starting the equipment Made in China Assembling and operation WORKZONE TITANIUM® is a registered trademark of ALDI Stores DISTRIBUTED BY: Electrical connection ALDI STORES 1 SARGENTS ROAD Maintenance MINCHINBURY NSW 2770 Storage www.aldi.com.au...
Explanation of symbols Explanation of symbols The use of symbols in this manual is intended to draw your attention to possible risks. The safety symbols and the explanations that accompany them must be understood before using the compressor. The warnings in themselves do not remove the risks and cannot replace correct actions for preventing accidents.
Introduction 1. Introduction Congratulations on choosing to buy a WORKZONE TITANIUM product. ® All products brought to you by WORKZONE TITANIUM are manufactured to the ® highest standards of performance and safety, and as part of our philosophy of customer service and satisfaction, are backed by our comprehensive 5 Years Warranty.
Scope of delivery/Intended use/Safety information m Attention! The compressor and packaging materials are not toys! Children must not be allowed to play with plastic bags, film and small parts! There is a risk of swallowing and suffocation! 4. Intended use The compressor is designed to generate compressed air for compressed-air driven tools which can be driven with an air volume of up to approx.
Page 7
Safety information m DANGER Failure to follow these instructions may cause serious danger to life or the risk of severe injuries. m WARNING Failure to follow these instructions may cause danger to life or danger of serious injuries. m CAUTION Failure to follow these instructions may cause light to medium risk of injury.
Page 8
Safety information Keep children away – Do not allow other persons to touch the equipment or cable, keep them away from your work area. Securely store unused electric tools – Unused electric tools should be stored in a dry, elevated or closed location out of the reach of children.
Page 9
Safety information conditions must be fulfilled to ensure fault-free operation of the electric tool. – Damaged protective devices and parts must be properly repaired or replaced by a recognised workshop, insofar as nothing different is specified in the operating manual. –...
Page 10
Safety information ADDITIONAL SAFETY INSTRUCTIONS Safety instructions for working with compressed air and blasting guns • The compressor pump and lines can become very hot during operation. Touching these parts will burn you. • The air which is sucked in by the compressor must be kept free of impurities that could cause fires or explosions in the compressor pump.
Safety information/Technical data Operating pressure vessels • You must keep your pressure vessel in good working order, operate the vessel correctly, monitor the vessel, carry out necessary maintenance and repair work immediately and meet the relevant safety precautions. • The supervisory authority may enforce essential control measures in individual cases.
Before starting the equipment/Assembling and operation 7. Before starting the equipment m Attention! Before you connect the equipment to the mains supply make sure that the data on the rating plate are identical to the mains data. • Check the equipment for damage which may have occurred in transit. Report any damage immediately to the transport company which was used to deliver the compressor.
Page 13
Assembling and operation 8.4 Fitting the transport handle (Fig. 1) • Fit the transport handle (1) using allen screws (1a) and allen key as shown in figure 8.5 Changing the transportation cover (A) (Fig. 9/10) • Remove the transportation cover from the oil filter opening (21) and insert the supplied oil sealing plug (16) into the oil filler opening.
Assembling and operation/Electrical connection 8.11 Overload switch (Fig. 13) The motor is fitted with an overload switch (20). If the compressor overloads, the overload switch switches off the equipment automatically to protect the compressor from overheating. If the overload switch triggers, switch off the compressor using the ON/ OFF switch (17) and wait until the compressor cools down.
Maintenance 10. Maintenance m Warning! Prior to any adjustment, maintenance or service work disconnect the mains power plug! m Important! Wait until the equipment has cooled down completely! Risk of burns! m Important! Always de-pressurize the equipment prior to any cleaning and maintenance work! Risk of injury! 10.1 Cleaning •...
Page 16
Maintenance 10.3 Safety valve (Fig. 3) The safety valve (19) has been set for the highest permitted pressure of the pressure vessel. It is prohibited to adjust the safety valve or remove its seal. Actuate the safety valve from time to time to ensure that it works when required. Pull the ring with sufficient force until you can hear the compressed air being released.
Storage/Disposal and recycling 11. Storage m Important! Pull out the mains plug and ventilate the equipment and all connected pneumatic tools. Switch off the compressor and make sure that it is secured in such a way that it cannot be started up again by any unauthorized person. m Important! Store the device and its accessories in a dark, dry and frost-proof place that is inacces- unauthorized persons...
Troubleshooting 13. Troubleshooting Fault Possible cause Remedy The compressor No supply voltage. Check the supply voltage, the power does not start. plug and the socket-outlet. Insufficient supply voltage. Make sure that the extension cable is not too long. Use an extension cable with large enough wires.
Page 20
Air Compressor Premium Warranty Details The product is guaranteed to be free from defects in workmanship and parts for a period of 60 months from the date of purchase. Defects that occur within this warranty period, under normal use and care, will be repaired, replaced or refunded at our discretion. The benefits conferred by this warranty are in addition to all rights and remedies in respect of the product that the consumer has under the Competition and Consumer Act 2010 and similar state and territory laws.
Page 21
Air Compressor Premium Repair and Refurbished Goods or Parts Notice Unfortunately, from time to time, faulty products are manufactured which need to be returned to the Supplier for repair. Please be aware that if your product is capable of retaining user-generated data (such as files stored on a computer hard drive, telephone numbers stored on a mobile telephone, songs stored on a portable media player, games saved on a games console or files stored on a USB memory stick) during the process of repair, some or all of your stored data may be lost.
Page 22
Overview Utilisation Contents of Box HC520 Contents of Box 23 24 25 1 x Air Compressor 1 x Air Filter (15) 2 x Supporting Foot (9) 2 x Wheel (11) 1 x Mounting Material 1 x Oil Drain Plug (16) 1 x Transport Handle (1) 1 x Instruction Manual 1 x Warranty Card...
Need help?
Do you have a question about the PREMIUM HC520 and is the answer not in the manual?
Questions and answers
Oil spurts out of oil sealing plug when compressor is turned on