Amplifier Functions - Malone Hotrod 2000 Manual

General:
• After turning on the amplifier, it might take 3 - 4 seconds until all functions are fully available and the speakers are
ready.
• Select the desired audio source by pressing INPUT repeatedly.
• Adjust the output volume level with VOL on the device front or +/- on the RC.
• Press MENU on the device front to access the settings for B (bass), T (treble), XBass, Speaker light with mic out,
MV (mic volume), EC (echo), speaker light with mic in. Use the multi function button on the device front or +/- on
the RC to adjust the settings values.
• When a USB drive is inserted while a CD is played, press SUBTITLE to copy files from CD to USB.
Radio
• Connect the supplied FM antenna for radio reception. Press INPUT repeatedly to select FM mode.
• Use CH+ / CH- on the RC to switch previously saved stations back and forth.
• Press TU+ / TU- to manually tune through the tuner band in steps of 0.05Hz.
• Press AUTO on the RC for an automatic scan. Found stations will be saved to presets in the order they were found.
• Press MEMO on the RC to save the current frequency to presets. Use the numpad to select the desired preset.
There is a total of 40 presets at your disposal.
• Toggle the preference for stereo or mono reception with the ST/MO button on the RC.
Karaoke
• The device automatically notes whether there are microphones connected to the MIC1 / MIC2 / MIC3 input jacks.
• Lower the volume before connecting the microphones - then adjust the volume to the desired level.
• Press MULTI MENU on the RC to show MV (mic vol) on the display. Then adjust with +/-.
• Press MULTI MENU repeatedly until EC (echo level) is shown. Adjust with +/- or, alternatively, use the knobs on the
rear of the device to adjust effects and volume levels.
• Please Note: To avoid hum and feedback, always be very gentle when turning the volume levels up. Do not try to
cover the microphone capsule with your hands (this is counterproductive) and do not point the microphone to to
speakers which will almost compulsory lead to hooting feedback when the output volume is beyond a certain level.
BT
• Activate BT on the device you want to pair with the Hotrod.
• Press INPUT repeatedly to select the BT mode. The flashing blue LED indicates, the Hotrod is in pairing mood.
• Connect your BT device (smartphone, tablet, laptop PC, etc.) to 10026818/10026819 and confirm. When prompted
to enter a password, please enter "0000"
• The connection attempt was successful, when the blue LED stops flashing and lights constantly.
• To disconnect, press STOP/DISCONNECT on the RC.

Amplifier Functions

18