Advertisement
Table of Contents
Document version v1.1
V1.00 :
Initial document
V1.10 :
Changed sync1 / sync2 parameter for PPQ speed
INTRODUCTION
Congratulations on your purchase of the Dtronics Nano Sync.
The Dtronics MS- 06 converts midi timing signals to adjustable DIN- sync and Jack- sync
outputs.
Features:
• Midi to sync converter with programmable clock dividers/multipliers.
• Din sync output and Jack sync output can be set to different clock speeds.
24 / 48 or 96PPQn
• Jack sync output for 1:1 to 1:127 of the clock input.
Led that shows the current clock speed (1/24 of clock frequency). And RUN status.
Power input: 9 to 12V DC, max 100mA. + on center pole.
Latency: <350uS
Clock edge difference between dinsync out1 and dinsync out2: 60nS
This product has been carefully engineered and thoroughly tested to guarantee
optimum performance and user satisfaction for many years to come.
Please read these instructions carefully!
Dtronics Nano Sync Manual
Advertisement
Table of Contents
Related Manuals for DTronics Nano Sync
Summary of Contents for DTronics Nano Sync
- Page 1 Changed sync1 / sync2 parameter for PPQ speed INTRODUCTION Congratulations on your purchase of the Dtronics Nano Sync. The Dtronics MS- 06 converts midi timing signals to adjustable DIN- sync and Jack- sync outputs. Features: •...
- Page 2 PROGRAMMING The NANO sync can be programmed to your needs. These settings are stored and will be used the next time you will turn on the unit. Each DINSync output can be programmed from 24 / 48 or 96PPGn The JACKSync output can be programmed from 1/1 to 1/127 of the input clock.
- Page 3 Example: F0 00 20 41 40 18 01 02 01 F7 Jack sync = 0x18 ( 24 decimal) jack output will be clock in divided by 24 (= 1 PPQn) Sync out1 = 0x01 = 24PPQn Sync out2 = 0x02 = 48PPQn Store = 0x01 Settings will be stored...
Need help?
Do you have a question about the Nano Sync and is the answer not in the manual?
Questions and answers