Page 1
ASSEMBLY AND INSTRUCTION 3 IN 1 STEAMING HOT WATER TAP INSTRUCTION The 3 in 1 steaming hot water tap is suitable for dispensing steaming hot water (98°C) and purified water.The steaming hot water hose of the steaming hot water tap be directly connected to the heating tank.
PRODUCT DIMENSION DRAWING 195mm 195mm 265mm Faucet Notice:suitable for fitment to work surfaces / sinks and tops of 60mm depth max.
Page 3
INTALLATION OF 3-IN -1 STEAMING HOT WATER TAP (Accessories) Adaptor (3/8 to 1/4) Adaptor (for filtered water) Adaptor (for steaming hot water) O-ring 6.4mm Push Fit Tube Clear Silicon Hose...
Page 4
INSTALLATION OF 3-IN-1 STEAMING HOT WATER TAP...
Page 5
*Install the couping nut on the boiling water hose * See the view of faucet bottom * Firstly, remove 4pcs of locking nut; and then please pass the 6.4mm push fit tube /clear silicon hose through the nuts, Finally, Please connect each tube to the tap and tighten the nut on the tap,as shown in Step 6~8.
Page 7
Step 3 - Connect Faucet to Tank Filtered Water In Steaming Hot Water Out Indicator Light Indicator Light (Red:Heating, (Red:OFF, Green :Steaming Green:ON) Hot Water) 98°C 90°C When you tighten the nut, use a wrench to hold the water pipe so that the water pipe will not be damaged. Please hold the water pipe until the nut is tightened (Do Not Overtighten) Adaptor...
Page 8
Step 3 - Connect Faucet to Tank Adaptor(3/8 To 1/4) (Filtered water in) Tank We advise that the filter is to be changed every 6 / 8 month depending on usage , to prevent any issues with water flow, lime scale /water debris build up.
Step 4 - Check For Leaks 1: Open valve in water line. 2: Turn boiling water handle on to fill tank (about 1 minute). When tank is full, water will flow from faucet , as shown in Figure 4. 3: Turn faucet off. Check for leaks. Figure 4 Step 5 - Prepare For Test 1:Plug electrical cord into a grounded 3-prong outlet.
Step 6 - Test Installation 98° Boiling water Handle Caution: Purified Water Handle The temperature of the watercan reach 98°C therefore care must be taken to avoid scalding Adaptor(3/8 To 1/4) Tank Notice: If the tank usage is taken to the limit the red light will re-appear on the tank as the amount of Steaming water has been used and the tank needs to refill and re-heat to the set temperature...