Table of Contents
Advertisement
Build up and Installation
Unpacking and checking
1. Take the product and its accessories carefully out of the packaging.
2. Check the package content for damage and / or completeness. If the package content is incomplete or damaged, do not
switch the product on. Bring it back to the place where you bought the product.
3. If you dispose the packaging materials, please adhere to the legal regulations.
4. Keep the packaging material if you want to pack, ship or transport the product.
Store it in a way that it shows no danger potential.
Warning - suffocation danger!
The packaging material is not a toy. children can choke on plastic bags, foils and polystyrene.
Therefore keep packaging material away from children.
Operation
Note - Place the product in direct sunlight to fully charge the batteries.
Switch on the product
1. Press the on / off button to turn on the product and manually adjust each color mode
(also see the section Selecting Color Mode).
2. The lamp automatically switches on at dusk and automatically turns off at dawn.
Note - When the batteries are exhausted, the product will automatically switch off to
avoid damage to the batteries and the article. In daylight, the batteries will automatically recharge.
pressed on/off
Color mode
button
1 x
red
2 x
green
3 x
blue
4 x
light blue
5 x
yellow-green
6 x
purple
7 x
warm-white
8 x
cold-white
automatic color changing
9 x
mode
10 x
out
Select color mode
Placing the product
Press the on / off button to choose
On the floor: insert the earth
between the different color modes of
spike into the holder in the cap
the article.
of the article. Then insert the
Please refer to the table below for the
earth spike into a soft ground.
sequence of color modes.
Note
Note
Make sure that the product is
When you select the color in daylight,
placed into the sun, so that the
the selected color lights up 3 seconds
batteries can be fully recharged
before the product automatically
in daylight.
turns off.
If pressed further, the next color lights
up in the order of the table.
12
Halterung
Halterung
an/aus-Schalter
an/aus-Schalter
1.
1.
max.
max.
2.
2.
2,5 kg
2,5 kg
Use in water
Use the hook to attach weights to it
(maximum 2.5 kg). With the weight on the
hook, the article stays in the water where
you put it.
Wind and water movements can then less
affect the position of the article.
Insert the hook into the opening on the floor.
Attach a weight (max 2.5 kg) to the hook.
Place the item in the desired position and
enjoy the sight.
Cleaning and storage
Note - Never use solvents and abrasives, hard brushes, metal or sharp objects when you clean the product.
Solvents are hazardous to health and attack the plastic parts , abrasive cleaners and tools to scratch the surface.
1. Clean the product with a damp cloth and – if necessary – use a mild detergent.
2. Dry the product carefully if you want to store it.
3. The item will not be used for a long time, keep it clean and protected from direct sunlight in a dry, cool place in its original
packaging.
Note - Before storing the product it must be turned off manually.
Specifications
Light source:
2 x 5050 LED RGB / 2 x 2835 LEDs (1 x warm-white / 1 x cold-white)
Power supply:
5050 RGB LED = 0,25W / 2835 LED = 0,5 W
Solar Panel:
max. 5.5 V
Burn time:
8 hours (depending on color mode)
IP Rating:
67
Battery:
1 x INR18650 1800mAh battery (rechargeable)
Warranty
ON/OFF
- For this article, the statutory warranty applies.
- The general warranty of 2 years from the date of purchase of the article applies to this article.
- The warranty does not cover abuse / or unappropriate use of the article.
- Keep the sales receipt along with the instruction manual, in case you may need to make use of the warranty.
Disposal methods
Please dispose the batteries environmentally suitable. Do not throw batteries into household waste.
Please use the return and collection systems in your community or contact the retailer where the product was purchased.
This sign indicates that electrical appliances in the EU must not be disposed of with normal household waste.
Please use the return and collection systems in your community or contact the retailer where the product was
purchased.
The packaging material is partially recyclable. Dispose of the packaging in an environmentally friendly and lead them to
the collection of recyclables.
The article complies with all standards which are necessary to obtain the CE-symbol. If necessary, please contact
the manufacturer at info@innocom-gmbh.de for the EC Declaration of Conformity of this product.
Importeur:
INNOcom GmbH
Ehnkenweg 9, 26125 Oldenburg,
Germany
Made in China
, 270 mA
Articlenr.:
210000
13
Advertisement
Table of Contents
