Advertisement
This portable water softener comes with new resin and is ready for use as soon as backwashing is completed.
WATER SUPPLY
ADAPTER
Pre-Flush
1. Connect your incoming water hose to the "OUT" port on the unit. Use the supplied female fitting if needed. (F. 1)
2. Connect an additional garden hose to the "IN" port on the unit and run it to a drain, driveway or grass area. (Optional:
if a garden hose is not available, place the unit on a flat surface or grass with area to release water). Insure the unit is
upright and leveled. (F. 2)
3. Turn the water on and flush the unit for 5 minutes, until the water flows clear. During your first use/wash, you might see
some color in your water. This is normal as the resin is new and will release particles on initial first flush. (F. 3)
4. Complete. You can now connect the unit.
WATER SUPPLY
OUT
IN
Connecting the unit
1. Connect your incoming water hose to the "IN" port on the unit. (F. 4)
2. Connect a garden hose to the "Out" port on the unit. (F. 5)
3. Connect the other end of the hose to your "IN" port on your recreational vehicle. (F. 6)
4. If installing this unit for travel, ensure that the unit is secured to your recreational vehicle to avoid damage to the unit and
to the inside of your recreational vehicle. Securing the unit with any strap, is recommended.
5. The unit must be installed upright - never install the unit on its side.
6. Complete. Your system is now ready to use.
WS-P-16 Guide: Getting Started
F. 1
OUT
F. 4
TO RV /
BOAT
OUT
IN
TO DRAIN
WATER SUPPLY
OUT
IN
PRO+AQUA
F. 2
OUT
F. 5
CITY WATER
& TANK FILL
TO RV / BOAT
WATER SUPPLY
OUT
IN
F. 3
IN
F. 6
(OPTIONAL)
PRE-FILTER /
REGENERATION KIT
PART#: WS-P-REG-KIT
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for PROAQUA WS-P-16
- Page 1 WS-P-16 Guide: Getting Started This portable water softener comes with new resin and is ready for use as soon as backwashing is completed. F. 1 F. 2 F. 3 WATER SUPPLY ADAPTER TO DRAIN Pre-Flush 1. Connect your incoming water hose to the “OUT” port on the unit. Use the supplied female fitting if needed. (F. 1) 2.
- Page 2 3. Connect one end of the Brine Hose to the “OUT” port of the WS-P- REG-KIT housing. CLOSE 4. Connect the other end of the brine hose to the “OUT” port of the CLOCKWISE WS-P-16 unit. Connection should be on the “OUT” to “OUT” ports. PORT PORT BRINE BRINE...
Need help?
Do you have a question about the WS-P-16 and is the answer not in the manual?
Questions and answers
Can I simply reconnect my water softener, WS-P-16 of it's been in storage for 3 months? The Easter and salt was not removed before storing.
@Rick The water and salt wasn't removed prior to storage