Samsung WW1 T Series User Manual page 61

Code
Addwash door is open
(applicable models only)
OC
LC, LC1
3C
3CP
UC
HC
1C
AC
8C
Untitled-3 61
This message appears when you open the Add Door without pressing Start/
Pause (Hold to Start). If this happens, do one of the following:
• Press the Add Door to close properly. Then, press and hold Start/Pause
(Hold to Start) and try again.
• To add laundry, open the Add Door and input laundry. Close the Add Door
properly. Then, press and hold Start/Pause (Hold to Start) to resume
operation.
Water has overflowed.
• Restart after spinning.
• If the information code remains on the display, contact a local Samsung
service centre.
Check the drain hose.
• Make sure the end of the drain hose is not placed on the floor.
• Make sure the drain hose is not clogged.
• If the information code remains, contact a customer service centre.
Check the drum motor for operation.
• Try restarting the cycle.
• If the information code remains, contact a customer service centre.
The electronic control needs to be checked.
• Try restarting the cycle.
• If the information code remains, contact a customer service centre.
Check the pulsator motor for operation.
• Check if power is supplied properly.
• If the information code remains, contact a customer service centre.
Low voltage detected.
• Check if the power cord is plugged in.
• If the information code remains, contact a customer service centre.
High temperature heating check.
• If the information code remains, contact a customer service centre.
The Water Level sensor is not working properly.
• Turn the machine off, and restart the cycle.
• If the information code remains, contact a customer service centre.
Check communications between main and sub PBAs.
• Turn the machine off, and restart the cycle.
• If the information code remains, contact a customer service centre.
The MEMS sensor is not working properly.
• Turn the machine off, and restart the cycle.
• If the information code remains, contact a customer service centre.
Action
English 61
8/5/2020 8:14:47 PM