Advertisement
95 Sherwood Avenue. Farmingdale, NY 11735
Instructions on how to setup the iAdapter™ Bluetooth® Audio
The following instructions are for Apple's iOS 7 or 8 and the built-in accessibility options. For users still
utilizing Apple's iOS6 or older, please see information on how to utilize our Bluetooth switch at the end of this
manual.
Power OFF/ON Switch – This switch turn the power onto the amplifier and the Bluetooth audio
module that will sync with the iPad
Bluetooth LED – This LED is used to indicate the status of the module. When flashing rapidly the
module is in pairing discovery mode, which means it is looking to sync with a device.
Charging LED – This LED will turn on when the USB charging plug is plugged into the USB charging
port. It will light RED.
The Bluetooth module works off of the existing internal battery of the iAdapter. If the internal battery of the
iAdapter loses power or if the Power switch turn set to the OFF position the Bluetooth module will turn off. As
soon as power is restored the Bluetooth module will sync with the iPad again.
www.amdi.net
iAdapter 5, 5A and 5A2
Power OFF/ON Switch
®.
Phone: (888) 353-2634
Bluetooth LED
Page 1 of 2
Fax: (631) 531-8811
Charging LED
888.353.2634
Advertisement
Table of Contents
Summary of Contents for Amdi iAdapter 5,5A
- Page 1 Power switch turn set to the OFF position the Bluetooth module will turn off. As soon as power is restored the Bluetooth module will sync with the iPad again. 888.353.2634 www.amdi.net Page 1 of 2...
- Page 2 3. At this point you should see the Bluetooth module come up on the device list (i.e. i5.01). 4. To sync the module to your iPad, at this point all you need to do is simply select the i5.01 device and the iPad will automatically sync. No code is required. 888.353.2634 www.amdi.net Page 2 of 2...
Need help?
Do you have a question about the iAdapter 5,5A and is the answer not in the manual?
Questions and answers