Advertisement
KISS CC (AIOv2) - new Member of the KISS integrated FC&ESCs
Family
This version of the All-in-One board by Flyduino consists of a KISS 32bit flight controller and 4x 32bit KISS ESCs, rated at
16A (21A active limit), great for mini FPV setups.
It's made for instant DIY success as you only need to solder motor wires, connect power and a radio and go.
The KISS CC should be ideally driven up to 4s and up to 4 inch props. 5 inch props are possible but you need to choose
motors carefully. The CC will actively limit the output to 21A.
Please read the following instructions carefully.
1
Advertisement
Table of Contents
Related Manuals for Flyduino KISS Series
Summary of Contents for Flyduino KISS Series
- Page 1 KISS CC (AIOv2) - new Member of the KISS integrated FC&ESCs Family This version of the All-in-One board by Flyduino consists of a KISS 32bit flight controller and 4x 32bit KISS ESCs, rated at 16A (21A active limit), great for mini FPV setups.
- Page 2 Specs of the CC Weight of PCB: 11g (without wires) Size 35x42mm (with cut off corners) Mounting holes 30x30mm, 3.2mm diameter 4x KISS ESC 32bit ESC's 2-4S 16A (21A active current limiter) KISS FC F3 32bit with serial, buzzer and LED ports ...
- Page 3 Connections & Wiring...
- Page 5 Motor Wires: To change the rotation direction you can use the [JP1] solder jumpers on top of the board to match Mot1/CW, Mot2/CCW, Mot3/CW and Mot4/CCW. So you can solder your wires straight to the motor pads and change the direction later by closing the matching solder jumpers next to the motor outputs on top of the board.
- Page 6 Complete Connection Plan by Philipp Seidel For further updates on the Connection Plan please visit Philipps Blog Also visit his frequently updated KISS Blog with loads of informations, manuals and more…...
Need help?
Do you have a question about the KISS Series and is the answer not in the manual?
Questions and answers