Advertisement
Quick Links
S200V / S300V QUICK REFERENCE GUIDE
The quick reference guide is not a substitute for the Operators Manual!
Please refer to Operators Manual for more detailed information
TRACTOR CONNECTION
1. Hydraulics
Red pipe
> Supply (35-40lpm)
Blue pipe
> Return (Free flow return!!)
2. Electrics
A. Connect 12V supply to 3pin plug
B. Connect wrapper harness to controller
ENTERING THE WORKING POSITION
1. Remove the wrap arm transport lock.
2. Position the safety arms into the working
position by removing the retaining pin.
3. Adjust the load arm stop pin to allow
clearance between the top of the bale at the
rotating arm.
4. Unfold the wrap arms and install the 2/3
rolls of film.
1
2
3
A
B
4
Advertisement
Summary of Contents for Tanco S200V
- Page 1 S200V / S300V QUICK REFERENCE GUIDE The quick reference guide is not a substitute for the Operators Manual! Please refer to Operators Manual for more detailed information TRACTOR CONNECTION 1. Hydraulics Red pipe > Supply (35-40lpm) Blue pipe > Return (Free flow return!!) 2.
- Page 2 OPERATION Auto mode (A) Auto load + Auto wrap Drive into the bale until the End Tip roller contacts the bale. The bale will then begin loading automatically. Once loading is complete, the wrapping process will begin automatically. Once wrapping is complete, press the “Rollers out”...
- Page 3 Auto start wrap cycle Pause wrapping in Auto OPTIONAL RF REMOTE OPERATION The RF (Radio Frequency) remote is required if you wish to operate the S200V / S300V statically. RF Receiver Auto Start wrap Load bale / add Offload the bale...
- Page 4 OPTIONAL HANDHELD REMOTE The operator can activate the main wrapper functions through the handheld remote. This means that the operator can hold the remote in their hand while operating the tractor. Manual Manual Slow rotate Reverse rotate forward Auto mode Auto mode Auto start wrap Auto start wrap...
Need help?
Do you have a question about the S200V and is the answer not in the manual?
Questions and answers