X5" Supply Voltage; X6" And "X7" Usb-2.0 Interfaces; Table 13: X5 Pin Assignment - WAGO Standard TP 600 762-4 Series Manual

Touch Panel Standard Line
762-4xxx TP 600
Table 1: X4 Pin Assignment
Pin Assignment
1 -
2 CAN-L (CAN data low)
3 GND (reference potential 0 V or ground)
4 -
5 -
6 -
7 CAN-H (CAN data high)
8 -
9 -
Continuous shielding is essential in order to increase the immunity to
interference. The metallic housing of the plug is capacitively connected to
functional ground.
The connected data cable must be shielded. The cable clamp that is used must
guarantee sufficient strain relief and contact between the shield and housing over
a large area at the same time.
4.4.7

"X5" Supply Voltage

Connect the supply voltage to the X5 connector. For this, use the included 734-
103 female connector featuring three CAGE CLAMP
For more information about the supply voltage, see section "Device Description"
> "Technical Data".

Table 13: X5 Pin Assignment

Pin
1
2
3
4.4.8

"X6" and "X7" USB-2.0 Interfaces

The USB 2.0 host interfaces are designed with 4-pin type A sockets. Each
interface can supply max. 500 mA.
The connectors comply with the USB 2.0 specification.
Keyboards or mice can be connected as alternative input devices or up to 2 USB
memory devices. These USB devices must be connected before power ON.
Description
24VDC
GND
FE
®
connections.
Assignment
Supply voltage: +24 VDC
Reference potential 0V (ground)
Functional earth
Properties 39
Manual
Version 1.3.0